Bedienungsanleitung Yamaha YST-SW305 (Seite 12 von 100) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Schwedisch)

559190

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

E-10

SUPERWOOFER SYSTEM YST-SW205

STANDBY/ B.A.S.S. HIGH CUT

40Hz

MOVIE

MUSIC

140Hz 100

VOLUME

OUTPUT

+ – +–

INPUT

AUTO

PHASE

STANDBY

INPUT

TO SPEAKERS

/MONO

LOW

NORM REV

OFF HIGH

FROM AMPLIFIER

POWER

OFF

8 1, 6

STANDBY/ B.A.S.S. HIGH CUT

40Hz

MOVIE

MUSIC

140Hz 100

VOLUME

PHASE

NORM

REV

1 Set the VOLUME control to minimum (0).

2 Turn on the power of all the other

components.

3 Make sure that the POWER switch is set to

the ON position, then press the STANDBY/

ON button to turn on the subwoofer.

* The power indicator lights up in green.

4 Play a source containing low-frequency

components and adjust the amplifier’s

volume control to the desired listening level.

5 Adjust the HIGH CUT control to the position

where the desired response can be

obtained.

Normally, set the control to the main speaker’s

rated minimum reproducible frequency*.

* The main speaker’s rated minimum

reproducible frequency can be looked up in the

speakers’ catalog or owner’s manual.

6 Increase the volume gradually to adjust the

volume balance between the subwoofer and

the main speakers.

Normally, set the control to the level where you

can obtain a little more bass effect than when this

unit is not used. If the desired response cannot

be obtained, adjust the HIGH CUT control and

the VOLUME control again.

Before using the subwoofer, adjust the subwoofer to obtain the optimum volume and tone balance between the subwoofer and

the main speakers by following the procedures described below.

7 Set the PHASE switch to the position which

gives you the better bass sound.

Normally, set the switch to the REV (reverse)

position. If the desired response cannot be

obtained, set the switch to the NORM (normal)

position.

8 Select “MOVIE” or “MUSIC” according to the

played source.

MOVIE: When a movie type source is played, the

low-frequency effects are enhanced to allow the

listener enjoy more powerful sound. (The sound

will be thicker and deeper.)

MUSIC: When an ordinary music source is

played, the excessive low-frequency components

are cut off to make the sound clearer. (The sound

will be lighter and reproduces the melody line

more clearly.)

• Once the volume balance between the subwoofer and

the main speakers is adjusted, you can adjust the

volume of your whole sound system by using the

amplifier’s volume control.

However, if you change the main speakers to others,

you must make this adjustment again.

• For adjusting the VOLUME control, the HIGH CUT

control and the PHASE switch, refer to “Frequency

characteristics” on the next page.

ADJUSTING THE SUBWOOFER BEFORE USE

Front panel

Rear panel

*Illustration shows YST-SW205.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha YST-SW305 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info