733741
24
Zoom out
Zoom in
Vorherige Seite
1/29
Nächste Seite
46 47
GB GB
Press S1 or S2 on the control panel to match the Robotic Mower's signal to
the docking station's. The button of the currently active signal is illuminated.
Home & start button
Press the START button and close the top cover and the Robotic Mower will begin cutting.
When the programmed work time is passed, the device will return to the docking station.
Important note:
The Robotic Mower will start working again the following day at the same time as when the
start button was pressed initially.
Example: You start the Robotic Mower on Monday at 15:30 with a working time of 4 h. The
device will work on Monday until 19:30 and then return to base. On Tuesday 15:30, the
Robotic Mower will automatically start again working for the same 4 h. This will continue
every day until interrupted by the user.
HOME
Pressing the HOME button and closing the lid will send the Robotic Mower back to the
docking station for a complete recharge. Note this will not stop the current programming. If
the working time has not run out when charging is complete, the device will start cutting
again. It will also start working again on the following day.
STOP
To interrupt the automatic working schedule, press the STOP button to open the top cover,
and close it again without pressing any control button. The Robotic Mower will beep ve
times to conrm the interruption. It will not resume working without further user commands.
OPERATION
OPERATION
Edge cutting
As the rst cutting action of each day, the Robotic Mower will trim the lawn edge. Therefore,
while cutting, it follows the boundary wire in clockwise direction.
This function only engages when the Robotic Mower launches from the charging
station.
Charging Information
The Robotic Mower will go back to docking station by itself in the following situations:
1. When you press the
button and close the keypad top cover.
2. When out of working time set.
3. When less than 30 % battery charge is remaining.
Note: If the Robotic Mower fails to dock to the docking station, it will return to the cutting
area and try again.
Note: If the ambient temperature around docking station is higher than 40 °C, the device will
stop charging to protect the battery. Once the temperature drops sufciently, charging will
resume automatically.
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

yard-force-sa650-eco

Suche zurücksetzen

  • yardforce Sa 650 Eco rote Led ist Ständig an über der alarmanzeige Eingereicht am 22-4-2022 13:34

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yardforce SA650 ECO wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Yardforce SA650 ECO

Yardforce SA650 ECO Bedienungsanleitung - Deutsch, Englisch, Holländisch, Französisch, Polnisch - 172 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info