Bedienungsanleitung Yeoman Exmoor (Seite 12 von 28) (Englisch)

813461

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Installation Instructions

1. General

1.1 TOOLS REQUIRED

No tools are required to install this appliance.

1.2 UNPACKING THE FIREPLACE

WARNING! DO NOT use this appliance if any part has

been exposed to water.

Immediately call a qualified service technician to inspect and

to replace any part of the electrical system if necessary.

1.3 Open the packaging carefully and remove the polystyrene.

Remove and discard the plastic bag.

Keep plastic wrapping away from children.

Be responsible when handling the packing materials.

1.4 Check all parts and accessories are removed before

disposing of any packaging.

If necessary keep the original packaging for future transport

and/or storage.

This appliance is heavy and does not require

anchoring to the hearth or floor, but in certain

circumstances the appliance can become

unstable e.g. when leaning on the appliance. If

this is likely, secure the appliance to the hearth

or floor with suitably strong fixings.

2. Locating the Appliance

The appliance may be installed virtually anywhere in your

home. However, when choosing a location ensure that the

general instructions are followed.

2.1 For best results, install out of direct sunlight.

2.2 If the power cord is damaged contact your Yeoman retailer

for a replacement. Only use genuine Yeoman parts on this

appliance.

2.3 The appliance should be located close to a suitable mains

socket to enable connection.

The electrical socket must be easily accessible to allow

disconnection when the appliance is fitted.

2.4 This appliance must stand on a clean, level, firm surface.

Do not stand the appliance on a carpet. Ensure that

furniture, curtains etc. are positioned no closer than 1m and

the appliance stands on a surface that can withstand

temperatures of 90°C for prolonged periods. Do not allow

rugs to be placed within 500mm of the front of the

appliance.

2.5 Ensure that curtains and furniture are not positioned close to

the chosen position, as this would create a potential fire

hazard or block the heater outlet ducts.

WARNING! KEEP ANY COMBUSTIBLE MATERIALS

AT LEAST 1M FROM THE FRONT AND SIDES OF THE

APPLIANCE.

ALL INGLENOOK FIREPLACE OPENINGS:

For all models the dimensions required for an inglenook

installation can be calculated by adding 225mm (9") to the

height of the appliance and 150mm (6") to each side. An

additional 50mm (2") must be added to the depth to provide

adequate space behind the appliance.

3. Fitting the Appliance

IMPORTANT: THE OUTER PANELLING IS MADE

FROM CAST IRON. USE CAUTION WHEN

INSTALLING, REMOVING AND STORING AS THE

COMPONENTS ARE HEAVY AND SHOULD BE

HANDLED CAREFULLY.

3.1 Position the stove ensuring all appropriate clearances are

observed.

EXMOOR & DARTMOOR SINGLE DOOR

3.2 Turn and pull right hand rose to open door, see Diagram 1.

1Dartmoor Shown

3.3 Pull the door open.

DARTMOOR DOUBLE DOOR

3.4 To open the door turn the knob on the right door to release

the catch, see Diagram 2.

3.5 Pull the doors open.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yeoman Exmoor Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info