Bedienungsanleitung Ygnis Varino (Seite 16 von 33) (Englisch)

638626

Zoom out

Zoom in

Vorherige Seite

1/33

Nächste Seite

PYROGAS VARINO 65 - 300

We reserve the right to make changes to dimensions and construction 14 Edition 02.09.2015

6.7. Hydraulic connection

6.7.1. General notice

For the hydraulic connection of the heating system and water heaters– in particular with regards to technical

safety devices such as safety valves, expansion tanks, etc. – refer to generally accepted engineering rules as

well as locally applicable standards, specifications and regulations.

If boilers are installed in garret-based heating plants or at the highest point of the heating system, then boilers

will have to be provided with additional safety devices (such as protections against water shortage). Observe the

minimum operating pressure as specified in chapter 4.5. Act in compliance with local safety regulations in force

at all times.

Boiler’s maximum operating pressure and the maximum operating temperature are given in chapter 4.1.

No minimum level of the amount of circulating water is required.

6.7.2. Water quality

Observe the required water quality according chapter 4.2. Anti-freeze should not be used.

Before connecting the boiler to an old installation, it is necessary to flush the whole heating system.

It is recommended to provide for a sludge separator.

Damage can occur from corrosion when oxygen continuously enters the heating water through open

installations, expansion tanks that are too small, floor heaters with pipe material that is not oxygen-tight, etc.

If this cannot be prevented, additional measures are necessary in the form of correctly used oxygen binding

agents or chemicals. If it is not possible to realize an installation without oxygen entrance, a system separation

must be set up using heat exchangers.

6.7.3. Boiler return flow

The condensing unit is fitted with a high temperature return flow in addition to the normal low temperature return

flow. Heating elements are connected to these with the maximum temperature level.

In order to ensure a high degree of efficiency of the boiler in each operating condition, care should be taken to

ensure that the low temperature return flow is supplied in each case.

It is not necessary to maintain the return flow temperature at a given level.

6.7.4. Draining the condensate

The condensates that result during condensation contain combustion products that are more or less acidic. Any

necessary approval for draining the condensate into the sewer system must be obtained from local authorities.

A condensate neutralisation set is available as an option, if desired

If the condensate is drained directly into the sewer system, then this must take place via an open funnel/hopper.

Important:

The recuperator is delivered with a siphon arranged in the casing. It must be ensured that no additional

siphon is installed since this would prevent the condensate from draining away. For the same reason, the

line to the funnel/hopper must have a slight gradient and should not show any slack!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ygnis Varino Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ygnis Varino

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info