DISCLAIMER
Y uneec Electric Aviation cannot be held liable for any damage, injury or for use of the product
in violation with legal regulations, especially in the following circumstances:
Damage and/or injury as well violation of legal regulations r esulting from a failure to comply
with the operating instructions or the instructions at www .yuneec.com, product information,
user manual and other legally binding information.
Damage and/or injury as well violation of legal regulations br ought about by the influence of
alcohol, drugs, medication or other narcotics which may impact on the concentration of the user .
The same applies to illnesses effecting the concentration of the user (dizziness, tiredness,
nausea etc.) or other factors compromising mental and physical capabilities.
Intentionally caused damage, injury or violation of legal regulations.
Any request for compensation caused by an accident r esulting from use of the product.
Damage and/or injury as well as violation of legal regulations caused by use of the pr oduct in
a no-fly zone, e.g. next to an airfield, above a motorway or a natural conservation area.
Malfunction of the product caused by r etrofitting or replacement with components which did
not come from Y uneecElectric Aviation.
Damage and/or injury caused by the use of replica parts (non-original parts).
Damage and/or injury as well as violation of legal regulations caused by incorr ect operation
or misjudgement.
Damage and/or injury caused by damaged spare parts or not using original Y uneec Electric
Aviation spar e parts.
Damage and/or injury as well as violation of legal regulations caused by ignoring the low
voltage battery warning.
Damage and/or injury caused by knowingly and negligibly flying with a damaged model or
one which is unfit to fly , e.g. due to dirt, water penetration, coarse particles, oil or a model
which has not been correctly or completely assembled or if the main components exhibit
visible damage, defects or missing parts.
Damage and/or injury as well as violation of legal regulations caused by operating the model
in a magnetic field (e.g. high voltage lines, electricity/transformer stations, radio towers,
mobile phone masts etc.), a strong wir eless signal environment,no-fly zones, poor visibility
and in the event of vision impairments or other impacts on the pilot which are left unchecked etc...
Damage and/or injury brought about thr ough a violation of the legal regulations for operat-
ing the model, in unsuitable weather conditions, e.g. rain, wind, snow , hail, storms, hurricanes etc.
Damage and/or injury as well as violation of legal regulations caused by for ce majeure, e.g.
collision, fire, explosion,flooding, tsunami, landslide, avalanche, earthquake or other forces of
nature.
Damage and/or injury as well as violation of legal regulations caused by the illegal or immoral
use of the model, e.g. capturing videos or recor ding data which infringes upon/harms the
privacy of other people.
Damage and/or injury as well as violation of legal regulations caused by incorr ect use of the
batteries, protection systems, char gers or aircraft.
Consequential damage caused by the incorrect operation of any kind of system components
and accessory parts, especially memory cards, wher eby image or video material from the
camera can become defect.
Any non-compliance with legal obligations, personal injury , material damage and environ-
mental damage caused by use and a failure to comply with the local laws and r egulations.
Damage and/or injury as well as violation of legal regulations caused by hazar dous use
without sufficient practical experience.
Damage and/or injury as well as violation of legal regulations caused by flying in legally
defined no-fly zones.
Further losses which do not fall within the scope of use defined by Y uneec Electric Aviation
as improper .
This product is designed for both professional use and personal, private use. The national and
international laws and regulations in for ce as the time of taking off must be adhered to.
FCC ST A TEMENT :
This equipment has been tested and found to comply with the limits for Part 15 of the FCC
rules. These limits are designed to pr ovide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates , uses and can radiate radio
frequency ener gy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However , there is no guarantee that interfer ence will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television r eception, which can be
determined by turning the equipment off and on, the user is encouraged to try to corr ect the
interference by one or mor e of the following measures:
• Reorient or relocate the r eceiving antenna.
• Increase the separation between the equipment and r eceiver .
• Connect the equipment to an outlet on a circuit dif ferent from that to which the receiver is
connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference r eceived, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pr ovide
reasonable pr otection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency ener gy and, if not installed and used in
accordance with the instructions, may cause harmful interfer ence to radio communications.
However , there is no guarantee that interfer ence will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment of f and on, the user is encour-
aged to try to correct the interfer ence by one or more of the following measures:
—Reorient or relocate the r eceiving antenna.
—Increase the separation between the equipment and r eceiver .
—Connect the equipment into an outlet on a circuit dif ferent from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modifications not expressly appr oved by the party responsible for
compliance could void the user's authority to operate this equipment.
RF EXPOSURE WARNING
• This equipment must be installed and operated in accordance with pr ovided instructions
and the antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located or operating in conjunction with
any other antenna or transmitter . End-users and installers must be provide with antenna
installation instructions and transmitter operating conditions for satisfying RF exposure
compliance.
IC RADIA TION EXPOSURE ST A TEMENT FOR CANADA
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interfer-
ence, and (2) this device must accept any interference, including interfer ence that may cause
undesired operation of the device.
Le présent appar eil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil
ne doit pas produir e de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouil-
lage radioélectrique subi, même si le brouillage est susceptible d'en compr omettre le
fonctionnement.
This equipment complies with IC RSS-102 radiation exposure limit set forth for an uncon-
trolled envir onment.
25