Bedienungsanleitung Zanker KOB57602 (Seite 16 von 44) (Deutsch, Englisch)

528970

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Stainless steel or aluminium appliances:

Clean the oven door with a wet sponge only. Dry

it with a soft cloth.

Do not use steel wool, acids or abrasive materials, as

they can cause damage to the oven surface. Clean the

oven control panel with the same precautions.

Shelf supports

You can remove the shelf supports to clean the side

walls.

Removing the shelf supports

Pull the front of the

shelf support away from

the side wall.

Pull the rear end of

the shelf support away

from the side wall and re-

move it.

Installing the shelf supports

Install the shelf supports in the opposite sequence.

The rounded ends of the shelf supports must

point to the front.

Pyrolysis

Warning! The appliance becomes very hot.

There is a risk of burns.

Caution! If a hob is installed with the appliance,

do not use it at the same times as the Pyrolysis

function. It can cause damage to the appliance.

1. Remove the removable shelf supports (if applica-

ble) and accessories from the appliance. Refer to

"Removing the shelf supports".

Caution! Do not let the removable shelf supports

stay in the appliance during the cleaning

procedure. There is a risk of damage.

2. Remove the worst dirt manually.

3. Fully close the oven door.

The cleaning procedure cannot start if you do not

close the oven door.

4. Set the function Pyrolysis. Refer to "Oven func-

tions".

When

flashes, press + or - to set the neces-

sary procedure:

– P1 - if the oven is not very dirty. The procedure

is 1 h long.

– P2 - if the oven is more dirty. The procedure is

1 h 30 min long.

Press

to start the procedure. You can use the

End function to delay the start of the cleaning.

When the oven is at the set temperature, the door

locks. The display shows the symbol

and the

bars of the heat indicator.

To stop Pyrolysis before it is completed, turn the

knob for the oven functions to the off position.

When Pyrolysis is completed, the display shows the

time of day. The oven door stays locked. When the ap-

pliance is cool again, an acoustic signal sounds and the

door unlocks.

During the Pyrolysis the oven lamp is off.

Cleaning reminder

To remind you that Pyrolysis is necessary, PYR flashes

in the display for 10 seconds after each activation and

deactivation of the appliance.

The cleaning reminder goes off the display:

• After the end of the Pyrolysis function

• If you press + and - at the same time while PYR

flashes in the display.

Oven lamp

Warning! Be careful when you change the oven

lamp. There is a risk of electrical shock.

Before you change the oven lamp:

• Deactivate the oven.

• Remove the fuses in the fuse box or deactivate the

circuit breaker.

Put a cloth on the bottom of the oven to prevent

damage to the oven light and glass cover.

Always hold the halogen lamp with a cloth to prevent

grease residue from burning on the lamp.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanker KOB57602 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zanker KOB57602

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info