Bedienungsanleitung Zanker mwc 291 e (Seite 7 von 31) (Englisch)

365571

Zoom out

Zoom in

Vorherige Seite

1/31

Nächste Seite

MWC291E t English

Unpacking

N.B. When you unpack the oven, check that the

product is free from damage. Damage or any missing

parts must be reported immediately to the retailer.

The oven, parts of the oven or the accessories may

be wrapped by a protection foil. If so, you must

remove this foil before using the oven. Do not leave

packing material so that small children can play with

it. This can be hazardous.

Installation

1. Remove any promotion label from the door.

2. Install the oven on a flat, level surface. The

surface must be strong enough to safely bear the

weight (21 kg) of the oven, and the contents. To

avoid the possibility of causing vibration or noise

the oven must be in a stable position.

3. Keep the oven away from heat and water.

Exposure to heat and water can lower oven

efficiency and lead to malfunctioning, so be sure

to install the oven away from heat and water

sources.

4. Do not block air vents on the top and the sides of

the cabinet and also do not place any articles on

the top of the oven. If air vents are blocked during

operation, the oven may overheat, and this may

lead to malfunctioning. Hot air escapes from the

vents, so be sure not to obstruct it or let curtains

come between the oven and the rear wall.

5. Place the oven as far away from radios and TV’s

as possible. This oven does conform to EEC

requirements* of radio interference suppression,

but some interference may occur if it is placed too

close to a radio or TV, so keep them as far apart

as possible.

If positioned in a corner, leave a gap of at least

5,0 cm from the walls to meet ventilation

demands.

Important! The oven can be placed almost anywhere

in the kitchen. Make sure the oven is placed on a flat,

level surface and that vents as well as the surface

underneath the oven are not blocked (for sufficient

ventilation).

* This appliance conforms to the requirements of

EEC Radio Interference Directive 87/308/EEC.

Connecting to the mains

The oven is delivered with the power cord and a plug

for 220-240V, 50Hz, earthed socket outlet. Earth

protection minimises the risks should a short-circuit

occur. Check to ensure the voltage of the oven

matches the supply.

N.B. If the oven is connected to the socket via an

extension cord, make sure the cord is earthed.

WARNING! This appliance must not be used on a

non-earth protected power supply.

Contact an electrician if you are uncertain regarding

electrical connection of the oven or provision of earth

protection of the supply.

This appliance must be earthed. If this appliance is

fitted with a non-rewireable plug for which your socket

is unsuitable, the plug should be cut off and the

appropriate plug fitted. If it is necessary to change the

fuse in a non-rewireable plug, the fuse cover must be

refitted. If the fuse cover is lost or damaged, the plug

must not be used until a replacement is obtained.

Getting Started

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanker mwc 291 e Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zanker mwc 291 e

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info