Bedienungsanleitung Zanker ZKB7630 (Seite 31 von 72) (Deutsch, Englisch, Holländisch, Französisch)

528925

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

• Clean the front of the appliance with a soft cloth with

warm water and cleaning agent.

• To clean metal surfaces use a usual cleaning agent

• Clean the oven interior after each use. Thus you can

remove dirt more easily and it does not burn on.

• Clean stubborn dirt with a special oven cleaner.

• Clean all oven accessories (with a soft cloth with

warm water and cleaning agent) after each use and

let them dry.

• If you have nonstick accessories, do not clean them

using an aggressive agents, sharp edged objects or

dishwasher. It can destroy nonstick coating!

Cleaning the door gasket

• Regularly do a check of the door gasket. The door

gasket is around the frame of the oven cavity. Do not

use the appliance if the door gasket is damaged.

Contact the Service Centre.

• To clean the door gasket refer to the general infor-

mation about the cleaning.

Pyrolytic cleaning

Warning! The appliance becomes very hot.

There is the risk of burns.

Important! Do not use Pyrolytic cleaning function and

the hob at the same time (if it is installed with the

appliance). It can cause a damage to the appliance.

Before Pyrolytic cleaning:

1. Remove all removable parts from the appliance.

To remove the shelf supports (if present), refer to

"Removing the shelf support rails".

2. Remove the worst of the dirt manually.

3. Close the oven door correctly.

Using the Pyrolytic cleaning

Press

again and again until the display shows

–

The display shows “Pyro” and

– An acoustic signal sounds to remind you to re-

move all removable parts from the oven.

– The temperature display shows „P1“ or „P2“

– The clock display shows "2:00" or "2:30"

–

Duration

flashes for approximately 5 sec-

onds.

While Duration

flashes, press or to set

the duration for the Pyrolytic cleaning:

– 2:00 for a low degree of dirt,

– 2:30 for a high degree of dirt.

Press

to start the Pyrolytic cleaning.

The bars on the symbol

come on one by one to

show that the temperature in the appliance increa-

ses.

When the appliance is at the preset temperature,

the door locks and the display shows

When the Pyrolytic cleaning is completed, the display

shows the time of day. The oven door is locked. When

the appliance cools down, an acoustic signal sounds

and the door unlocks.

To stop the pyrolytic cleaning at any time, press

End time for Pyrolytic cleaning

You can set the end time for Pyrolytic cleaning

with the clock function End

1. Do again step 1,2 and 3 from above procedure.

Press

The display shows an arrow and the symbol

The display shows the time for the end of Pyrolytic

cleaning.

Press

or to adjust the time for the end of

the Pyrolytic cleaning.

Removable shelf runners and catalytic panels

To clean the oven cavity remove the shelf runners and

catalytic panels.

Warning! Be careful when you remove the shelf

runners. The catalytic panels are not attached to

the oven cavity and can fall out when you remove the

shelf runners.

Warning! Before maintenance, make sure that

the appliance is cool. There is risk of burns

because of residual heat.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanker ZKB7630 Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info