Bedienungsanleitung Zanussi ZDF 312 (Seite 27 von 68) (Holländisch)

76528

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Activate or deactivate the multitab function before

the start of a washing programme.

You cannot activate or deactivate the multitab function

when the programme operates. Cancel the washing pro-

gramme, then set the programme again.

To activate the multitab function:

• Press and hold the two multitab buttons (function but-

tons D and E). The multitab indicator light comes on.

To deactivate the multitab function:

• Press and hold the two multitab buttons (function but-

tons D and E). The multitab indicator light goes off.

Do these steps if the drying results are not satis-

factory:

1. Fill the rinse aid dispenser with rinse aid.

2. Activate the rinse aid dispenser.

3. Set the rinse aid dosage to position 2.

• You can only activate or deactivate the rinse aid dis-

penser when the multitab function is activated.

To activate the rinse aid dispenser:

1. Switch on the appliance.

2. Make sure that the appliance is in setting mode.

3. Press and hold function buttons B and C.

– The indicator lights for function buttons A, B, and

C start to flash.

4. Press function button B.

– The indicator lights for function buttons A and C

go off.

– The indicator light for function button B continues

to flash.

5. Press function button B again.

– The end indicator light comes on.

6. Switch off the appliance to save the operation.

To deactivate the rinse aid dispenser do the above steps

until the end indicator light goes off.

To use normal detergent again:

1. Deactivate the multitab function.

2. Fill the salt container and rinse aid dispenser.

3. Adjust the water hardness setting to the highest level.

4. Do a washing programme without dishes.

5. Adjust the water softener to the water hardness in your

area.

6. Adjust the rinse aid dosage.

Setting and starting a washing programme

Set the washing programme with the door ajar. The

washing programme only starts after you close the

door. Until then it is possible to modify the settings.

Do these steps to set and start a washing programme:

1. Switch on the appliance.

2. Make sure that the appliance is in setting mode.

3. Press one of the programme buttons. Refer to the

chapter 'Washing programmes'.

– The programme indicator light comes on.

– All other programme indicator lights go off.

4. Close the door.

– The washing programme starts automatically.

When the washing programme operates, you cannot

change the programme. Cancel the washing pro-

gramme.

Warning! Only interrupt or cancel a washing

programme if necessary.

Caution! Open the door carefully. Hot steam can

come free.

Cancelling a washing programme

1. Press and hold function buttons B and C until all the

programme lights come on.

2. Release function buttons B and C to cancel the wash-

ing programme.

At this time you can do these steps:

1. Switch off the appliance.

2. Set a new washing programme .

Fill the detergent dispenser with detergent before you set

a new washing programme.

Interrupting a washing programme

Open the door.

• The programme stops.

Close the door.

• The programme continues from the point of interrup-

tion.

Setting and starting a washing programme with

delay start

1. Press the on/off button.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZDF 312 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info