Bedienungsanleitung Zanussi ZDF4010 (Seite 12 von 52) (Englisch, Französisch, Spanisch)

626613

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Cancelling a washing programme

1. Press and hold function buttons B and C until:

– All the programme lights come on,

– The programme-in-progress indicator light goes

off.

2. Release function buttons B and C to cancel the wash-

ing programme.

At this time you can do these steps:

1. Switch off the appliance.

2. Set a new washing programme .

Fill the detergent dispenser with detergent before you

set a new washing programme.

Interrupting a washing programme

Open the door.

• The programme stops.

Close the door.

• The programme continues from the point of interrup-

tion.

Setting and starting a washing programme with

delay start

1. Press the on/off button.

2. Set a washing programme.

3. Press the delay start button until the display shows

on flashing the necessary delay start of the washing

programme.

4. Close the door.

– The number on the display comes on with fixed

light.

– The programme-in-progress indicator light goes

off.

– The countdown of the delay start starts.

– The countdown of the delay start decreases with

steps of 1 hour.

– When the countdown is completed, the washing

programme starts automatically.

– The programme-in-progress indicator light

comes on.

Do not open the door during the countdown to pre-

vent interruption of the countdown. When you

close the door again, the countdown continues from the

point of interruption.

Cancelling a delay start:

1. Press and hold function buttons B and C until:

– All the programme lights come on.

When you cancel a delay start, you also cancel the

washing programme.

2. Set a new washing programme.

End of the washing programme

• The appliance stops automatically.

• The display shows 0.

• The end-of-programme indicator light comes on.

• The programme-in-progress indicator light goes off.

1. Switch off the appliance.

2. Open the door.

3. For better drying results, keep the door ajar for

some minutes before you remove the dishes.

Let the dishes cool down before you remove them from

the appliance. Hot dishes are easily damaged.

Removing the load

• First remove items from the lower basket, then from

the upper basket.

• There can be water on the sides and door of the appli-

ance. Stainless steel becomes cool more quickly

than the dishes.

Standby mode

If you do not switch off the appliance at the end of the

washing programme, the appliance automatically goes

into standby mode. The standby mode decreases ener-

gy consumption.

Three minutes after the end of the programme, all indi-

cator lights go off and the digital display shows one hor-

izontal bar.

Press one of the buttons (not the on/off button), to go

back to end-of-programme mode.

Care and cleaning

Warning! Switch the appliance off before you

clean the filters.

Cleaning the filters

Important! Do not use the appliance without the filters.

Make sure that the installation of the filters is correct.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZDF4010 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zanussi ZDF4010

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info