Bedienungsanleitung Zanussi ZDI26010XA (Seite 31 von 56) (Englisch, Holländisch, Französisch)

628686

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Problem and alarm code Possible cause and solution

The program does not start. • Make sure that the appliance door is closed.

• If the delay start is set, cancel the setting or wait for the end of

the countdown.

• The appliance has started the procedure to recharge the resin

inside the water softener. The duration of the procedure is ap-

proximately 5 minutes.

The appliance does not fill with

water.

The display shows .

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not too low.

For this information, contact your local water authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not clogged.

• Make sure that the inlet hose has no kinks or bends.

The appliance does not drain

the water.

The display shows .

• Make sure that the sink spigot is not clogged.

• Make sure that the filter in the outlet hose is not clogged.

• Make sure that the interior filter system is not clogged.

• Make sure that the drain hose has no kinks or bends.

The anti-flood device is on.

The display shows .

• Close the water tap and contact an Authorised Service Centre.

The appliance stops and starts

more times during operation.

• It is normal. It provides optimal cleaning results and energy sav-

ings.

The program lasts too long. • If the delayed start option is set, cancel the delay setting or wait

for the end of the countdown.

The remaining time in the dis-

play increases and skips nearly

to the end of program time.

• This is not a defect. The appliance is working correctly.

Small leak from the appliance

door.

• The appliance is not level. Loosen or tighten the adjustable feet

(if applicable).

• The appliance door is not centred on the tub. Adjust the rear

foot (if applicable).

The appliance door is difficult

to close.

• The appliance is not level. Loosen or tighten the adjustable feet

(if applicable).

• Parts of the tableware are protruding from the baskets.

Rattling/knocking sounds from

inside the appliance.

• The tableware is not properly arranged in the baskets. Refer to

basket loading leaflet.

• Make sure that the spray arms can rotate freely.

The appliance trips the circuit-

beaker.

• The amperage is insufficient to supply simultaneously all the ap-

pliances in use. Check the socket amperage and the capacity

of the meter or turn off one of the appliances in use.

• Internal electrical fault of the appliance. Contact an Authorised

Service Centre.

Refer to "Before first use", "Daily

use", or "Hints and tips" for other

possible causes.

Once you have checked the appliance, deactivate

and activate the appliance. If the problem occurs

again, contact an Authorised Service Centre.

For alarm codes not described in the table, contact

an Authorised Service Centre.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZDI26010XA Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zanussi ZDI26010XA

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info