Bedienungsanleitung Zanussi ZGNT640X (Seite 8 von 20) (Englisch)

766211

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

WARNING! Make sure to place the

gasket exactly in the original position.

WARNING! Make sure the flame does

not go out when you quickly turn the

knob from the maximum position to the

minimum position.

ELECTRICAL CONNECTION

• Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug (if

applicable).

• The appliance must not be connected with an

extension cable, an adapter or a multiple socket.

There is a risk of fire.

• Do not let the power cable to heat up to a

temperature of more than 90° C. The cable

should be guided by means of clamps fixed to

the side of the cabinet, in order to avoid any

contact with the appliance beneath the cooktop.

• Make sure that there is access to the mains plug

after the installation.

Electrical Requirements

Permanent electrical installation must agree with

the latest I.E.E. Regulations and local Electricity

Board regulations. For your own safety the

installation must be done by a qualified electrician

(e.g. your local Electricity Board, or a contractor

who is on the roll of the National Inspection Council

for Electrical Installation Contracting [NICEIC]).

The manufacturer refuses to be

held responsible, if these safety

measures are not abided by.

Supply connections

This hob has to be connected to 220-240 V (~

50-60 Hz ) electricity supply.

The hob has a terminal block which is

marked as follows:

•L — Live terminal

•N — Neutral terminal

• or E — Earth terminal

Before carrying out the connection, make sure:

1. The limiter valve and the electrical system can

take the appliance load (see the rating plate)

2. The supply system is equipped with an efficient

earth connection in compliance with the current

standards and regulations

3. The outlet or omnipolar switch used for

connection is easily accessible with the

appliance installed.

The appliance is supplied with a 3 core flexible

power cable with a 3 amp plug. If it is necessary to

change the fuse, use a 3 amp ASTA-approved (BS

1362) fuse.

A B

A. Green and Yellow

B. 3 amp fuse

C. Brown

D. Cord clamp

E. Blue

The wires in the cord are coloured as follows:

Green and yellow - Earth

Blue - Neutral

Brown - Live

WARNING! A cut off plug inserted

into a 13 amp socket is a serious

shock hazard. Ensure that the cut off

plug is disposed of safely.

REPLACEMENT OF THE CONNECTION

CABLE

The replacement of electric cable must

be carried out exclusively by the

service force centre or by personnel

with similar competencies, in

accordance with the current

regulations.

To replace the connection cable use

only H03V2V2-F T90 or equivalent

type. Make sure that the cable section

is applicable to the voltage load and

the working temperature. The yellow/

green earth wire (B) must be

approximately 2 cm longer than the

live and neutral wire (A).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZGNT640X Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info