Bedienungsanleitung Zanussi ZRB 324WO1 (Seite 7 von 30) (Englisch, Holländisch)

447667

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

How to save energy

Avoid pulling the appliance in a sunny place and •

near anything that gives off heat.

Be sure that the condenser and the compressor are •

well ventilated. Do not cover the sections where

ventilation is.

Wrap products in tightly closing dishes or cling film •

to avoid building up unnecessary frost.

Do not leave the door open longer than necessary •

and avoid unnecessary openings.

Put warm foods into the appliance when they are at •

room temperature.

Keep the condenser clean. •

The appliance and environment

This appliance does not contain gasses which could

damage the ozone layer, in either its refrigerant circuit

or insulation materials. The appliance shall not be

discarded together with the urban refuse and rubbish.

Avoid damaging the cooling unit, especially at the rear

near the heat exchanger. Information on your local

disposal sites may be obtained from your municipal

authorities.

The materials used on this appliance marked with the

symbol are recyclable.

Maintenance

Defrosting

Bleeding part of the moisture of cooling chambers in

form of frost and ice goes with the operation of the

appliance.

Thick frost and ice has an insulating effect, so it reduces

cooling efficiency as the temperature increases in the

cooling chambers and they need more energy.

At this type of appliance defrosting the cooling plate

of the refrigerator is automatic without any external

intervention. The thermostatic control interrupts the

operation of compressor at regular intervals for more

or less time during this cooling is interrupted the

temperature of the cooling plate goes above 0 °C due to

interior heating load of the compartment, so defrosting

occurs. When the surface temperature of the cooling

plate has reached +3 - +4 °C the thermostatic control

restarts operation of the system.

Melting water flows through defrost water outlet leaded

through the back into the evaporative tray maintained on

the top of compressor and evaporates due to its warmth.

Check and clean the outlet of melting water

coming during defrosting regularly

a label inside the appliance warns you –

for this. If it is clogged the melting water

gathered can cause earlier failure as it can

go to the insulating of the appliance

Clean the melting water outlet with the supplied pipe

scraper that can be seen in the figure above.

The pipe scraper has to be stored in the outlet.

The most typical case of clogging up in the melting

water outlet when you put food wrapped in some paper

into the appliance and this paper contacts back plate of

the refrigerator and freezes to it. If you remove the food

right at this moment the paper will tear and it can cause

clogging up in the outlet by gelling into it.

So you are asked to be careful because of the

above when placing foods wrapped in paper into the

appliance. In case of increased demand e.g. during heat

waves, the refrigerator temporarily happens to operate

constantly. During this the automatic defrosting is

ineffective.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZRB 324WO1 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info