Bedienungsanleitung Zanussi ZRB 634 FW (Seite 28 von 56) (Deutsch, Englisch, Holländisch, Französisch)

70667

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Important! Do not pull, move or damage any pipes and/

or cables inside the cabinet.

Never use detergents, abrasive powders, highly perfumed

cleaning products or wax polishes to clean the interior as

this will damage the surface and leave a strong odour.

Clean the condenser (black grill) and the compressor at

the back of the appliance with a brush or a vacuum cleaner.

This operation will improve the performance of the ap-

pliance and save electricity consumption.

Important! Take care of not to damage the cooling system.

Many proprietary kitchen surface cleaners contain chem-

icals that can attack/damage the plastics used in this ap-

pliance. For this reason it is recommended that the outer

casing of this appliance is only cleaned with warm water

with a little washing-up liquid added.

After cleaning, reconnect the equipment to the mains

supply.

Defrosting of the refrigerator

Frost is automatically eliminated from the evaporator of

the refrigerator compartment every time the motor com-

pressor stops, during normal use. The defrost water

drains out through a trough into a special container at the

back of the appliance, over the motor compressor, where

it evaporates.

It is important to periodically clean the defrost water drain

hole in the middle of the refrigerator compartment channel

to prevent the water overflowing and dripping onto the

food inside. Use the special cleaner provided, which you

will find already inserted into the drain hole.

Defrosting of the freezer

The freezer compartment of this model, on the other hand,

is a "no frost" type. This means that there is no buildup

of frost when it is in operation, neither on the internal walls

nor on the foods.

The absence of frost is due to the continuous circulation

of cold air inside the compartment, driven by an auto-

matically controlled fan.

What to do if…

Caution! Before troubleshooting, disconnect the

power supply.

Only a qualified electrician or competent person must do

the troubleshooting that is not in this manual.

Important! There are some sounds during normal use

(compressor, refrigerant circulation).

Problem Possible cause Solution

The appliance is noisy. The appliance is not supported prop-

erly.

Check if the appliance stands stable (all

the four feet should be on the floor).

The compressor operates con-

tinually.

The Temperature regulator may be set

incorrectly.

Set a warmer temperature.

The door is not closed correctly. Refer to "Closing the door".

The door has been opened too fre-

quently.

Do not keep the door open longer than

necessary.

The product temperature is too high. Let the product temperature decrease to

room temperature before storage.

The room temperature is too high. Decrease the room temperature.

Water flows on the rear plate of

the refrigerator.

During the automatic defrosting proc-

ess, frost defrosts on the rear plate.

This is correct.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZRB 634 FW Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info