Bedienungsanleitung Zanussi ZRB 936XL (Seite 19 von 52) (Deutsch, Englisch, Holländisch, Französisch)

447674

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

er. This operation will improve the performance of the ap-

pliance and save electricity consumption.

Important! Take care of not to damage the cooling system.

Many proprietary kitchen surface cleaners contain chemi-

cals that can attack/damage the plastics used in this appli-

ance. For this reason it is recommended that the outer

casing of this appliance is only cleaned with warm water

with a little washing-up liquid added.

After cleaning, reconnect the equipment to the mains sup-

ply.

Defrosting of the refrigerator

Frost is automatically eliminated from the evaporator of

the refrigerator compartment every time the motor com-

pressor stops, during normal use. The defrost water

drains out through a trough into a special container at the

back of the appliance, over the motor compressor, where

it evaporates.

It is important to periodically clean the defrost water drain

hole in the middle of the refrigerator compartment channel

to prevent the water overflowing and dripping onto the

food inside. Use the special cleaner provided, which you

will find already inserted into the drain hole.

Defrosting the freezer

A certain amount of frost will always form on the freezer

shelves and around the top compartment.

Defrost the freezer when the frost layer reaches a thickness

of about 3-5 mm.

To remove the frost, follow the instructions below:

• pull out the plug from the wall socket or switch off the

appliance

• remove any stored food, wrap it in several layers of

newspaper and put it in a cool place

• remove the freezer drawers

• put insulating material around the drawers, e.g. blan-

kets or newspapers.

Defrosting can be accelerated by placing bowls with hot

water (not boiling) inside the freezer.

• Loosen the drainage channel from its resting position,

push it in according to the illustration and place it in

the bottom freezer drawer where water can collect

• carefully scrape off the ice when it starts to thaw. Use a

wood or a plastic scraper

• when all the ice has melted, clean and wipe the cabinet

dry, then put the drainage channel back in place.

• switch on the cabinet and replace the frozen foodstuff.

It is recommended to operate the appliance at the highest

position of the thermostatic control for some hours so that

it can reach the sufficient storing temperature as soon as

possible.

Important! Never use sharp metal tools to scrape off frost

from the evaporator as you could damage it. Do not use a

mechanical device or any artificial means to speed up the

thawing process other than those recommended by the

manufacturer. A temperature rise of the frozen food packs,

during defrosting, may shorten their safe storage life.

What to do if…

Caution! Before troubleshooting, disconnect the

power supply.

Only a qualified electrician or competent person must do

the troubleshooting that is not in this manual.

Important! There are some sounds during normal use

(compressor, refrigerant circulation).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZRB 936XL Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info