Bedienungsanleitung Zanussi ZRG14800WA (Seite 17 von 56) (Englisch)

766273

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

• It is advisable to wait at least four hours be-

fore connecting the appliance to allow the

oil to flow back in the compressor.

• Adequate air circulation should be around

the appliance, lacking this leads to over-

heating. To achieve sufficient ventilation fol-

low the instructions relevant to installation.

• Wherever possible the back of the product

should be against a wall to avoid touching

or catching warm parts (compressor, con-

denser) to prevent possible burn.

• The appliance must not be located close to

radiators or cookers.

• Make sure that the mains plug is accessible

after the installation of the appliance.

• Connect to potable water supply only (If a

water connection is foreseen).

Service

• Any electrical work required to do the serv-

icing of the appliance should be carried out

by a qualified electrician or competent per-

son.

• This product must be serviced by an author-

ized Service Centre, and only genuine spare

parts must be used.

Environment Protection

This appliance does not contain gasses

which could damage the ozone layer, in

either its refrigerant circuit or insulation materi-

als. The appliance shall not be discarded to-

gether with the urban refuse and rubbish. The

insulation foam contains flammable gases: the

appliance shall be disposed according to the

applicable regulations to obtain from your local

authorities. Avoid damaging the cooling unit,

especially at the rear near the heat exchanger.

The materials used on this appliance marked

by the symbol are recyclable.

Operation

Switching on

Insert the plug into the wall socket.

Turn the Temperature regulator clockwise to a

medium setting.

Switching off

To turn off the appliance, turn the Temperature

regulator to the "O" position.

Temperature regulation

The temperature is automatically regulated.

To operate the appliance, proceed as follows:

• turn the Temperature regulator toward lower

settings to obtain the minimum coldness.

• turn the Temperature regulator toward high-

er settings to obtain the maximum coldness.

A medium setting is generally the most

suitable.

However, the exact setting should be chosen

keeping in mind that the temperature inside

the appliance depends on:

• room temperature

• how often the door is opened

• the quantity of food stored

• the location of the appliance.

Important! If the ambient temperature is high

or the appliance is fully loaded, and the

appliance is set to the lowest temperatures, it

may run continuously causing frost to form on

the rear wall. In this case the dial must be set

to a higher temperature to allow automatic

defrosting and therefore reduced energy

consumption.

First use

Cleaning the interior

Before using the appliance for the first time,

wash the interior and all internal accessories

with lukewarm water and some neutral soap

so as to remove the typical smell of a brand-

new product, then dry thoroughly.

www.zanussi.com

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZRG14800WA Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zanussi ZRG14800WA

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info