The plastic bag of accessories also contains two
spacers to be fitted into special holes in the back of
the appliance. Fit the spacers into the holes, taking
care to ensure that the arrow (A) is positioned as
shown in Figure. Then turn them through 45° (arrow
(A) vertical) until they lock into place.
Do not stand the appliance on a sunny place or close to a
radiator or cooker.
If it is unavoidable because of furnishing and the appli-
ance has to be stood near a cooker take these minimum
distances into consideration:
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5 - 1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must be
30 cms since they give off more heat.
The refrigerator is designed to operate when it is totally
pushed to the wall.
When placing the refrigerator keep minimal dis-
tances recommended in figure.
A : placing it under a wall-cupboard
B : placing it freely
Change of door opening direction
Should the setting-up place or handling demand it, door-
opening direction can be refitted from right-handed to
left-handed.
Appliances on the market are right-handed.
Following operations are to be done on the basis of fig-
ures and explanations:
Disconnect the appliance from the electricity supply.
Tilt back the appliance carefully. It is recommended
to ask another person for help, who can keep the
appliance at this position safely.
Unscrew on the both sides adjustable feet (2 pieces)
and the fixing screws (2 pieces) of bottom door hold-
er and the far side screws (2 pieces) too.
Take off the door of the refrigerator by pulling it slight-
ly downwards.
Dismount the double door holder by removing the
screws (2 pieces).
Take off the door of the freezer by pulling it slightly
downwards.
Unscrew the top door holding pin of the freezer, then
screw it back on the other side.
Remove the covering nails of the double door holder
on the left side and put them to the other side.
Fit the door of the freezer to the top door holding pin.
GB