Bedienungsanleitung Zanussi ZTAE31EB1 (Seite 7 von 20) (Englisch)

766339

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

in a place with direct sunlight. Make sure that air

can circulate freely around the back of the cabinet.

This appliance should be installed in a dry, well

ventilated indoor position.

To ensure best performance, if the appliance is

positioned below an overhanging wall unit, the

minimum distance between the top of the cabinet

shall be maintained. Ideally, however, the appliance

should not be positioned below overhanging wall

units. One or more adjustable feet at the base of

the cabinet ensure that the appliance stands level.

CAUTION! If you position the

appliance against the wall, use back

spacers provided or keep the minimum

distance indicated in the installation

instructions.

CAUTION! If you install the appliance

next to a wall, refer to the installation

instructions to understand the

minimum distance between the wall

and the side of the appliance where

door hinges are to provide enough

space to open the door when the

internal equipment is removed (e.g.

when cleaning).

This appliance is intended to be used at ambient

temperature ranging from 10°C to 43°C.

The correct operation of the appliance

can only be guaranteed within the

speciﬁed temperature range.

If you have any doubts regarding

where to install the appliance, please

turn to the vendor, to our customer

service or to the nearest Authorised

Service Centre.

It must be possible to disconnect the

appliance from the mains power

supply. The plug must therefore be

easily accessible after installation.

ELECTRICAL CONNECTION

CAUTION! Any electrical work

required to install this appliance

should be carried out by a qualiﬁed

electrician or competent person.

WARNING! This appliance must be

earthed.

The manufacturer declines any liability

should these safety measures not be

observed.

The wires in the mains lead are coloured in

accordance with the following code:

A B

•A - green and yellow: Earth

•C - brown: Live

•D - blue: Neutral

As the colours of the wires in the mains lead of this

appliance may not correspond with the coloured

markings identifying the terminals in your plug,

proceed as follows:

1. Connect the wire coloured green and yellow to

the terminal marked either with the letter “E“ or

by the earth symbol or coloured green and

yellow.

2. Connect the wire coloured blue to the terminal

either marked with the letter “N“ or coloured

black.

3. Connect the wire coloured brown to the

terminal either marked with the “L“ or coloured

red.

4. Check that no cut, or stray strands of wire is

present and the cord clamp (E) is secure over

the outer sheath.

Make sure the electricity supply voltage is the

same as that indicated on the appliance rating

plate.

5. Switch on the appliance.

The appliance is supplied with a 13 amp fuse (B).

In the event of having to change the fuse in the plug

supplied, a 13 amp ASTA approved (BS 1362)

fuse must be used.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZTAE31EB1 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info