Bedienungsanleitung Zanussi ZTB 271 (Seite 27 von 32) (Englisch)

71983

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

longer drying times and higher energy consumption. If

the hose is completely squashed, the safety cut-outs with

which the machine is fitted may operate. When operating

the tumble dryer, the room temperature must not be lower

than +5°C and higher than +35°C, as it may affect the

performance of the appliance.

Electrical connection

Details on mains voltage, type of current and the fuses

required should be taken from the rating plate. The rating

plate is fitted near the loading aperture (see “Product de-

scription” chapter).

Connect the machine to an earthed socket, in accordance

with current wiring regulations.

Warning! The manufacturer declines any

responsibility for damage or injury through failure

to comply with the above safety precautions.

Should the appliance power supply cable need to be

replaced, this must be carried out by an authorised service

engineer or a qualified electrician. .

The appliance is supplied with a 13 amp plug fitted. In the

event of having to change the fuse in the plug supplied,

a 13 amp ASTA approved BS 1363/A fuse must be used.

The wires in the mains lead are coloured in accordance

with the following code:

1 Blue - Neutral

2 cord clamp

3 Brown - Live

4 Green and Yellow - Earth

The wire coloured green and yellow must be connected

to the terminal marked with the letter «E» or by the earth

symbol

or coloured green and yellow.

The wire coloured blue must be connected to the terminal

«N» or coloured black.

The wire coloured brown must be connected to the ter-

minal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands

of wire present and the cord clamp must be secure over

the outer sheath.

Warning! A cut off plug inserted into a 13 amp

socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely.

Warning! The plug must be accessible after

installing the machine.

Permanent connection

In the case of permanent connection it is necessary that

you install a double pole switch between the appliance

and the electricity supply (mains), with a minimum gap

of 3 mm between the switch contacts and of a type suitable

for the required load in compliance with the current elec-

trical regulations.

The switch must not break the yellow and green earth

cable at any point.

Door reversal

To make it easier to load or unload the laundry, the door

can be reversed. The door must only be reversed by an

authorised service engineer. Please contact your local

Service Force Centre. The engineer will carry out the door

reversal at your cost.

Special accessories

Stacking kit

A special stacking kit is

available through your deal-

er, to enable the mounting of

the dyer on top of a front

loading washing machine

with cover’s depth between

48 and 60 cm. Read carefully

the instructions supplied

with the kit.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZTB 271 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zanussi ZTB 271

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info