Bedienungsanleitung Zanussi ZWF 81463WH (Seite 16 von 20) (Englisch)

551563

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Problem Possible solution

The appliance does not fill

with water properly.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not too low. For

this information, contact your local water authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter of the inlet hose and the filter of the valve

are not clogged. Refer to “Care and cleaning”.

• Make sure that the inlet hose has no kinks or bends.

• Make sure that the connection of the water inlet hose is correct.

The appliance does not

drain the water.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Make sure that the connection of the drain hose is correct.

• Set the drain option if you set a programme without drain phase.

• Set the drain option if you set an option which ends with water in

the drum.

• If above mentioned solutions do not help, contact the Authorised

Service Centre (as the filter of the drain pump may be clogged).

The spin phase does not

operate or the washing cy-

cle lasts longer than usual-

ly.

• Adjust manually the items in the tub and start the spin phase again.

This problem may be caused by balance problems.

• Set the spin option.

• Set the drain option if you set an option which ends with water in

the drum.

• If above mentioned solutions do not help, contact the Authorised

Service Centre (as the filter of the drain pump may be clogged).

There is water on the floor.

• Make sure that the couplings of the water hoses are tight and there

is not water leakages.

• Make sure that the water inlet hose and the drain hose have no

damages.

• Make sure you use the correct detergent and the correct quantity

of it.

You cannot open the appli-

ance door.

• Make sure that the washing programme is finished.

• Set the drain or the spin option if there is water in the drum.

• Do the emergency drain procedure. See "Frost precautions" (in

"Care and Cleaning" chapter).

The appliance makes an

unusual noise.

• Make sure the levelling of the appliance is correct. Refer to 'Instal-

lation instruction'.

• Make sure that the packaging and/or the transit bolts are removed.

Refer to 'Installation instruction'.

• Add more laundry in the drum. The load may be too small.

The appliance fills with wa-

ter and drain immediately.

• Make sure that the drain hose is in the correct position. The end of

the hose may be too low. Refer to 'Installation instruction'.

The cycle is shorter than

the time displayed.

• The appliance calculates a new time according to the laundry load.

See the ‘Consumption Values’ chapter.

The cycle is longer than

the time displayed.

• An unbalanced laundry load increases the duration time. This is a

normal behaviour of the appliance.

16 www.zanussi.com

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZWF 81463WH Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zanussi ZWF 81463WH

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info