25
Water inlet
An inlet hose is supplied and can been found inside the
machine drum.
Do not use the hose from your previous machine to
connect to the water supply.
1. Open the porthole and extract the inlet hose .
2. Connect the hose with the angled connection to the
machine.
Important!
Do not place the inlet hose downwards. Angle the
hose to the left or right depending on the position of
your water tap.
3. Set the hose correctly by loosening the ring nut. After
positioning the inlet hose, be sure to tighten the ring
nut again to prevent leaks.
4. Connect the hose to a tap with a 3/4” thread. Always
use the hose supplied with the appliance.
Installation should comply with local water authority
and building regulations’ requirements.
The appliance must be connected to a cold water
supply.
A minimum water pressure of 0.05 MPa (0.5 bar) is
required for safe operation of the appliance.
If you cannot make the cold water connection direct
from the rising mains, you may be able to operate the
appliance from your cold water storage system.
There should be a minimum distance of 5.02m
(16.5 ft) between the appliance’s inlet and the bottom of
the water storage tank.
Water drainage
This appliance is designed to be permanently plumbed
into your home's drainage system using one of the
following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using
the “U” piece” supplied.
Place the drain hose into your standpipe, which should
have an internal diameter of approximately 38mm thus
ensuring there is an air break between the drain hose
and standpipe.
When discharging into a standpipe ensure that the top of
the standpipe is no more than 90cm (35.4'') and no less
than 60cm (23.6'') above floor level.
Min. 60 cm (23.6)
Max. 90 cm (35.4)
