Bedienungsanleitung Zanussi ZWF388 (Seite 14 von 25) (Englisch)

24719

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

ENGLISH

10. Interrupting a programme

Depress INICIO / PAUSA button to interrupt a

running programme, the corresponding light will

begin flashing. Press this button again to re-start the

programme.

11. Opening the door after the

programme has started

Firstly, stop the machine by pressing

INICIO / PAUSA button.

After about two or three minutes the door can be

opened.

If the door does not open , this means that the

temperature of the water is too high, that the water

level exceed the lower limit of the door (which could

cause overflowing) or that the drum is spinning.

If the door cannot be opened but you need to open it,

switch the machine off by turning the selector dial to

“O”. After approximately two or three minutes the

door can be opened. (PAY ATTENTION TO THE

WATER LEVEL AND TEMPERATURE!)

12. At the end of the programme

The machine stops automatically.

Release of the lock is indicated when FIN light

comes on.

Turn the programme selector dial to position “O” to

switch the machine off.

Remove the laundry from the drum and carefully

check that the drum is empty.

If you do not intend to put in another wash, turn off

the water tap. Leave the door open to prevent from

forming mildew and unpleasant smells.

ATTENTION!

If the RINSE HOLD option has been selected,

the last rinse water does not drain. To drain the

water, carry out the following steps:

1. Turn the programme selector dial to “

O”.

2. Select DRAIN or SPIN programme.

If programme (SPIN) has been selected:

Use the spin speed selector dial to choose the

required speed. If the dial is kept in the same

position as at the beginning, in other words

RINSE HOLD (no-wrinkle) position, the machine

will spin at 400 r.p.m.

3. Press INICIO / PAUSA button

7. OPTIONAL! Select, if required,

“DELAY START” option button

Push “DELAY START” button as many times as

necessary until the corresponding light to the

required delay (12H, 8H, 4H y 2H) comes on.

8. Start the machine

Before starting the machine check that:

• the appliance is plugged in.

• the water supply tap is turned on.

• the drain hose is correctly and securely positioned.

• the door and the detergent dispenser drawer are

closed.

To start the selected programme, push

INICIO / PAUSA button; the corresponding light will

stop flashing and will remain lit until the end of the

programme.

If “DELAY START” option has been chosen, the

machine will begin the countdown.

9. Modification of a running

washing programme

Once the programme has started, it only can be

modified by turning the programme selector dial to

“O” and afterwards the new programme can be

chosen.

The washing water remains in the tub, provided that

the machine does not reach the rinse phase, since,

in this case, the machine drains it automatically.

Start the new programme by pressing

INICIO / PAUSA button.

35.293.017…ZWF388.qxd 30/3/06 17:32 Página 41

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZWF388 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zanussi ZWF388

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info