Bedienungsanleitung Zanussi ZWF725B4PW (Seite 29 von 32) (Englisch)

765785

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

If the display shows other alarm codes, deactivate and activate the appliance. If

the problem continues, contact the Authorised Service Centre.

In case of different problem with the washing machine check the table below for

possible solutions.

Problem Possible solution

The programme does

not start.

• Make sure that the mains plug is connected to the mains socket.

• Make sure that the appliance door is closed.

• Make sure that there is no damaged fuse in the fuse box.

• Make sure that the Start/Pause has been touched.

• If the delay start is set, cancel the setting or wait for the end of count-

down.

• Deactivate the Child Lock function if it is on.

• Check the position of the knob on the selected programme.

The appliance ﬁlls with

water and drains imme-

diately.

• Make sure that the drain hose is in the correct position. The hose may

be positioned too low. Refer to "Installation instruction".

The spin phase does

not operate or the

washing cycle lasts lon-

ger than usual.

• Set the spin programme.

• This problem may be caused by the clogged drain circuit. Please con-

tact the Authorised Service Centre.

• Adjust manually the items in the tub and start the spin phase again.

This problem may be caused by balance problems.

There is water on the

ﬂoor.

• Make sure that the couplings of the water hoses are tight and there is

not water leakages.

• Make sure that the water inlet hose and the drain hose have no dam-

ages.

• Make sure you use the correct detergent and the correct quantity of it.

You cannot open the

appliance door.

• Make sure that a washing programme that ends with water in tub, has

not been selected.

• Make sure that the washing programme is ﬁnished.

• Set the drain or the spin programme if there is water in the drum.

• Make sure that the appliance receives electrical power.

• This problem may be caused by a failure of the appliance. Contact the

Authorised Service Centre.

The appliance makes an

unusual noise and vi-

brates.

• Make sure the levelling of the appliance is correct. Refer to "Installa-

tion instruction".

• Make sure that the packaging and/or the transit bolts are removed.

Refer to "Installation instruction".

• Add more laundry in the drum. The load may be too small.

The programme dura-

tion increases or de-

creases during pro-

gramme execution.

• The AutoSense System is able to adjust the programme duration ac-

cording to the type and the laundry load size. Refer to "The AutoSense

System load detection" in "Daily Use" chapter.

The washing results are

not satisfactory.

• Increase the detergent quantity or use a different detergent.

• Use special products to remove the stubborn stains before you wash

the laundry.

• Make sure that you set the correct temperature.

• Decrease the laundry load.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZWF725B4PW Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info