Bedienungsanleitung Zanussi ZWF825B4DG (Seite 20 von 32) (Englisch)

765776

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

THE AUTOSENSE SYSTEM LOAD

DETECTION

After touching the Start/Pause button:

1. The AutoSense System starts estimating the

weight of the load to calculate the real

programme duration. During this phase the

display shows the simple animation.

2. After about 10-15 minutes new cycle duration

is displayed.

The appliance automatically adjusts the

programme duration to the load to achieve

perfect washing results in the minimum

possible time.

INTERRUPTING A PROGRAMME AND

CHANGING THE OPTIONS

You can change only some options before they

operate.

1. Press .

The indicator ﬂashes.

2. Change the options.

3. Press again.

The programme continues.

CANCELLING A RUNNING PROGRAMME

1. Turn the programme knob to position to

cancel the programme and to deactivate the

appliance.

2. Turn the programme knob again to activate the

appliance. Now, you can set a new washing

programme.

Before starting the new programme

the appliance could drain the water. In

this case, make sure that the detergent

is still in the detergent compartment, if

not ﬁll the detergent again.

OPENING THE DOOR WHEN THE DELAY

START OPERATES

While a delay start operates, the appliance door is

locked and the indicator is on.

1. Press to pause the appliance.

The indicator starts ﬂashing.

2. Wait about 2 minutes until the door lock

indicator stops ﬂashing and goes off.

3. You can open the door.

4. Close the door and press the again.

The delay start continues to operate.

OPENING THE DOOR WHEN THE

PROGRAMME OPERATES

While a programme operates, the appliance door is

locked and the indicator is on.

CAUTION! If the temperature and

level of the water in the drum are too

high, you cannot open the door.

1. Turn the programme knob to position to

deactivate the appliance.

2. Wait for some minutes and then open the

appliance door.

3. Close the appliance door.

4. Set the programme again.

AT THE END OF THE PROGRAMME

• The appliance stops automatically.

• The acoustic signal operates (if it is activated).

• In the display comes on.

• The indicator of the goes off.

• The door lock indicator ﬂashes for a few

minutes, then goes off.

• You can open the door.

• Remove the laundry from the appliance. Make

sure that the drum is empty.

• Close the water tap.

• Turn the programme knob to position to

deactivate the appliance.

• Keep the door ajar, to prevent the mildew and

odours.

The washing programme is completed, but

there is water in the drum:

• The drum turns regularly to prevent the creases

in the laundry.

• The door lock indicator is on. The indicator

ﬂashes. The door stays locked.

• You must drain the water to open the door.

To drain the water:

1. Press . The appliance drains the water and

spins.

2. When the programme is completed, the door

lock indicator ﬂashes for a few minutes.

When it goes off, you can open the door.

3. Turn the programme knob to position to

deactivate the appliance.

The appliance drains and spins

automatically after approximately 18

hours (except for Wool programme).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZWF825B4DG Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info