Bedienungsanleitung Zanussi ZWG 5145 (Seite 7 von 24) (Englisch)

70609

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Pull out the dispenser drawer until it stops. Measure

out the amount of detergent required, pour it into the

main wash compartment

or in the appropriate com-

partment if the selected programme/option it requires

(see more details in "Detergent dispenser drawer").

If required, pour fabric softener into the compartment

marked

(the amount used must not exceed the

«MAX» mark in the drawer). Close the drawer gently.

Select the required programme by turning the

programme selector dial (1)

Turn the programme selector dial to the required pro-

gramme. The washing machine will automatically select

the maximum spin value provided for the programme you

have chosen. You can change this value by pressing the

corresponding button. The green pilot light of the button

5 starts to flash.

The selector dial can be turned either clockwise or coun-

terclockwise. Turn to position

to reset programme/

Switching the machine off.

At the end of the programme the selector dial must be

turned to position

, to switch the machine off.

Caution! If you turn the programme selector dial to

another programme when the machine is working,

the red pilot light of button 5 will blink 3 times to indicate

a wrong selection. The machine will not perform the new

selected programme.

Select the spin speed or Rinse Hold option by

pressing button 2

The relevant light will light up.

When selecting a programme, the light corresponding to

the maximum speed allowed for that programme will il-

luminate.

Select the available options by pressing buttons 3

and 4

Depending on the programme, different functions can be

combined. These must be selected after choosing the de-

sired programme and before starting the programme.

When these buttons are pressed, the corresponding pilot

lights illuminate. When they are pressed again, the pilot

lights go out. If an incorrect option is selected, the inte-

grated red pilot light of the button 5 flashes for 3 times.

For the compatibility among the washing pro-

grammes and the options see chapter «Washing

Programmes».

Start the programme by pressing button 5

To start the selected programme, press the button 5 , the

corresponding green pilot light stops blinking. The pilot

light corresponding to the running phase illuminates. The

appliance starts operating and the door is locked.

To interrupt a programme which is running, press the

button 5 : the corresponding green pilot light starts blink-

ing.

To restart the programme from the point at which it was

interrupted, press the button 5 again . If you have chosen

a delayed start, the machine will begin the countdown.

If an incorrect option is selected, the red pilot light of the

button 5 blinks 3 times.

Interrupting a programme

Press the button 5 to interrupt a programme which is

running, the corresponding green pilot light starts blink-

ing.

Press the button again to restart the programme.

Cancelling a programme

Turn the selector dial to to cancel a programme which

is running. Now you can select a new programme.

Opening the door

After the programme has started the door is locked. If, for

any reason, you need to open it, set firstly the machine to

PAUSE by pressing the button 5 . After a few minutes it

will be possible to open the door.

If the door remains locked, this means that the machine

is already heating or that the water level is too high. In

any case, do not try to force the door!

If you cannot open the door but you need to open it you

have to switch the machine off by turning the selector dial

. After a few minutes the door can be opened (pay

attention to the water level and temperature!) .

After closing the door, it is necessary to select the pro-

gramme and options again and to press button 5 .

At the end of the programme

The machine stops automatically. The pilot light of button

5 and the pilot light corresponding to the just finished

washing phase go off. The light 7.3 illuminates. After a

few minutes the door can be opened.

If a programme or an option that ends with water left in

the tub has been selected, the light 7.3 illuminates but the

door remains locked to indicate that the water must be

emptied out before opening the door.

Follow the below instructions to empty out the water:

Turn the programme selector dial to

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZWG 5145 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zanussi ZWG 5145

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info