Bedienungsanleitung Zanussi ZWY 61205SA (Seite 3 von 20) (Englisch)

671306

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

• The operating water pressure (minimum and maximum) must be

between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa).

• The ventilation openings in the base (if applicable) must not be

obstructed by a carpet.

• The appliance is to be connected to the water mains using the

new supplied hose-sets. Old hose sets must not be reused.

• If the supply cord is damaged, it must be replaced by the

manufacturer, its Authorised Service Centre or similarly

qualified persons in order to avoid a hazard.

• Before maintenance, deactivate the appliance and disconnect

the mains plug from the mains socket.

• Do not use water spray and steam to clean the appliance.

• Clean the appliance with a moist soft cloth. Only use neutral

detergents. Do not use abrasive products, abrasive cleaning

pads, solvents or metal objects.

Safety instructions

Installation

• Remove all the packaging and the transit

bolts.

• Keep the transit bolts. When you move the

appliance again you must block the drum.

• Always be careful when you move the

appliance because it is heavy. Always wear

safety gloves.

• Do not install or use a damaged appliance.

• Obey the installation instruction supplied

with the appliance.

• Do not install or use the appliance where the

temperature is less than 0 °C or where it is

exposed to the weather.

• Make sure that the floor where you install the

appliance is flat, stable, heat resistant and

clean.

• Make sure that there is air circulation

between the appliance and the floor.

• Adjust the feet to have the necessary space

between the appliance and the carpet.

• Do not install the appliance where the

appliance lid can not be fully opened.

Electrical connection

• The appliance must be earthed.

• Always use a correctly installed shockproof

socket.

• Make sure that the electrical information on

the rating plate agrees with the power

supply. If not, contact an electrician.

• Do not use multi-plug adapters and

extension cables.

• Make sure not to cause damage to the

mains plug and to the mains cable. Should

the mains cable need to be replaced, this

must be carried out by our Authorised

Service Centre.

• Connect the mains plug to the mains socket

only at the end of the installation. Make sure

that there is access to the mains plug after

the installation.

• Do not touch the mains cable or the mains

plug with wet hands.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• Only for UK and Ireland: The appliance has a

13 amp mains plug. If it is necessary to

change the fuse in the mains plug, use a 13

amp ASTA (BS 1362) fuse.

• This appliance complies with the E.E.C.

Directives.

Water connection

• Make sure not to cause damage to the water

hoses.

www.zanussi.com 3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zanussi ZWY 61205SA Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info