Bedienungsanleitung ZCS 9L2BL (Seite 12 von 36) (Englisch)

517530

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

User’s manual

Marking the boundary of the work area

3. Check the entire lawn surface and assess whether it is necessary to

divide it into separate work areas. Before installing the perimeter wire,

check the entire path to make this procedure easier. The illustration

shows an example of a lawn with the track for burying the perimeter

wire.

During installation, identify any secondary areas and closed areas. A

secondary area is a section of lawn connected to the primary lawn

with a passage that is difﬁ cult for the robot to reach. The area must

be reachable without any rises or drops greater than those allowed.

Whether a zone is to be deﬁ ned a “secondary area” also depends on

the size of the primary area. The larger the primary area, the harder it

will be to reach narrow passages. More generally, a passage narrower

than 200 cm (78.74 ") is considered a secondary area. The number

of secondary areas managed depends on the characteristics of the

model (See “Technical Speciﬁ cations”).

The minimum passage allowed is 70 cm (27.56 ") from each edge of

the perimeter. The perimeter wire must be positioned at a distance of

(to be indicated below) from any objects outside the lawn; therefore,

the total passage should be 140 cm (55.12 ").

If this passage is very long, then it is better for the passage to be wider

than 70 cm (27.56 ").

During programming, it is necessary to conﬁ gure the size of the

secondary areas as a percentage of the lawn, and the quickest

direction for reaching it (clockwise or anti-clockwise), as well as the

number of meters of wire needed to reach the secondary area. See

“Programming Mode.”

24 v

Track for laying the perimeter wire

min. 70 cm / 27,56 "min. 70 cm / 27,56 "

min. 70 cm / 27,56 "

corridor with a minimum passage

of 70 cm / 27,56 " from edge to edge.

PRIMARY AREA

SECONDARY AREA

If the aforesaid minimum requirements are not met and therefore, i.e.

an area separated by a rise or drop with characteristics that cannot be

managed by the robot or a passage (corridor) narrower than 70 cm

(27.56 ") from perimeter edge to perimeter edge, this area of the lawn

area is considered a “Closed Area.” To mark a “Closed Area” lay the

outgoing and incoming perimeter wire in the same track at a maximum

distance of 1 cm (0.40 "). In this case, the robot is unable to reach

the area autonomously and must be managed as described in the

chapter “Management of Closed Areas.” The management of “Closed

Areas” reduces the square meters that can be managed by the robot

autonomously. It is recommended to use the “Management of Closed

Areas” only for areas smaller than 900 m2 (9684 sq.').

corridor with a passage

< 70 cm / 27,56 "

PRIMARY AREA

CLOSED AREA

drain cover

flowerbed

30 cm./ 11,8 "

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ZCS 9L2BL Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ZCS 9L2BL

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info