9
Operation Notes:
In areas with low or too high reception-field strength, interference-free
reception is not always guaranteed. If the signal level is too low, a directional
antenna should be placed outside the building.
In the immediate vicinity of the transmitter, reception may be impaired by a
too high reception level. In this case, you should avoid setting up the antenna
near a window.
Indoor radio reception can also be impaired by other factors:
- rooms in reinforced concrete buildings
- rooms with vapour-plated windows
- in positions directly beside transmitting electronic devices (e.g. mobile
phones)
Installation (Please refer to illustration):
Step 1. Take the IEC cable attached, and then connect one end to the IEC port,
and the other end to your DVB-T receiver shown in illustration
Attention! Don´t connect to a Satellite-Receiver!
Step 2. Take the power adaptor attached and Insert the end of DC connector into
DC jack on the back of AA 05, and then plug in the A/C end.
***** If your DVB-T receiver (e.g. from Zehnder) supplies with 5 VDC from
IEC connector, then it is not necessary to use the power adaptor.
Step 3. Take the standing unit attached , and then plug into the hole shown in
illustration to keep it standing. Before, check the position of rotating hole
for either vertical or horizontal direction.
Step 4. Connect your receiver and your TV by Scart Cable (see receiver manual)
and switch them on.
***** If your DVB-T receiver supplies with 5 VDC, ensure in the set-up menu
of the receiver, that the power supply to the antenna via the coax cable
is switched on.
