Bedienungsanleitung Zelmer 04Z011 (Seite 43 von 46) (Englisch, Polnisch)

538912

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

GW04-004_v01

Dear Customers

Congratulations on your choice of our appliance, and

welcome among the users of Zelmer products.

In order to achieve best possible results we recommend

using exclusively original Zelmer accessories. They have

been specially designed for this product.

Please read these instructions carefully. A special attention

should be drawn to the indications concerning safety in order

to prevent accidents and/or avoid destroying of the appliance

during the use of the deep fat fryer. We recommend you

keep this Use & Care Manual so that you could refer to it at

a later time of using the fryer.

Safety and proper use

Please read these instructions completely before

●

operating the fryer.

The fryer should always be connected to an electrical

●

socket (of only alternating current) equipped with a pro-

tection bolt and of voltage corresponding to that indicated

on a data plate of the appliance.

The fryer is intended for household use. If used

●

for purposes of gastronomic activities, the terms of

guarantee change.

Always put the appliance on a horizontal and even surface.

●

Never pull out a plug out of a socket by pulling a cable.

●

Never start the fryer if:

●

a power supply cord or a plug are damaged, ●

the fryer is damaged in any way, ●

an inner pot has not been lled with oil or if it is not up ●

to the level between indication marks of MIN and MAX,

the fryer is not in a normal position of operations. ●

If the non-detachable part of the cord is damaged, it should

●

be replaced by the producer or at a proper service point or

by a qualied person in order to avoid any hazards.

Only trained persons may repair the appliance. An

●

incorrectly made repair may cause a serious hazard for

the user. In the case of any defects, we advise you to

turn to a specialist service centre.

ATTENTION! Remember that a level of oil in a pot should

always be between indication marks of MIN and MAX on

an inner part of a pot. Then, frying will be correct.

If a level of oil is higher than a MAX level, it may result in

●

splashing of hot oil and burning oneself.

If a level of oil is lower than a MIN level, a thermal fuse

●

may switch off the appliance. In such a case, leave an

immer-sion heater to cool and next ll a pot with oil up to

a relevant level and follow the instructions of the Use &

Care Manual (the chapter “Operation and use”).

ATTENTION! The use of the fryer with a too little

amount of oil (below a MIN level) may result in

overheating of heating elements of the appliance and,

in consequence, its damage.

If a thermal fuse switches off the appliance despite

●

a proper level of oil in a pot, it is a sign of a failure of the

fryer. In such an event, turn to a specialist service centre.

The fryer is intended for frying food only.

●

Before using the appliance check whether the voltage

●

indicated on a data plate corresponds to that of electrical

power supply.

Do not place the appliance close to or on the places

●

being a source of heat (a heating plate etc.).

Remember that oil and certain parts of the fryer heat up

●

during frying to very high temperatures. Because of that

it is recommended to avoid touching them. For operation

of the appliance use buttons and handles.

During frying do not move or carry the fryer. After frying

●

the appliance may be moved or carried only after oil in

a pot has cooled.

Do not plunge in water heating elements or parts

●

containing heating elements, i.e. the casing of the fryer.

Make sure the oil basin is properly installed in the

●

housing according to the marks in the upper left corner

of the housing and on the oil basin . If the basin is

placed in a different position, the lid will not close.

Keep the appliance out of the reach of children when

●

you use it. Do not let the power supply cord touch hot

surfaces as well as hang over the edge of the table or

worktop on which the fryer is standing. In this way you

will avoid an acci-dental pulling and, in consequence, an

uncontrolled movement of the appliance.

This appliance is not intended for use by persons (including

●

children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not

●

play with the appliance.

The appliance is not intended to be operated by means

●

of an external timer or separate remote-control system.

After you have used the fryer, set the temperature

●

control to the lowest setting (turn it completely to the left).

Remove the plug from the wall socket and let the oil or

fat cool down.

Never leave water in the pot for oil. Also there cannot be

●

any water in a pot when it is lled with oil because it may

re-sult in splashing of oil or even a small explosion.

Do not hang over oil the pot with frozen food if oil is

●

not sufciently heated (min. 130°C). It may result in

a dangerous splashing of oil.

Excessive ice should be removed from frozen food in

●

order to prevent splashing of oil.

It should be made sure that the above instructions

have been understood.

Specications

Technical parameters are indicated on the data plate of the

appliance.

Capacity of the pot:

04Z011: min. 2,2 l, max 2,5 l. –

04Z012: min. 1,5 l, max 1,7 l. –

The fryer is the appliance of Class I, equipped with a power

supply cord with protection wire and a plug with a protection

bolt.

Zelmer 04Z011 Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info