Bedienungsanleitung Zelmer 23Z010 (Seite 54 von 56) (Englisch, Polnisch)

538919

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

WATER CONTAINER PROTECTION

This appliance is equipped with an internal water contain-

er (D) which is fastened with a band to protect the water

lever switch during transportation. Before the initial use,

remove the water container from the appliance and re-

move the band (see picture below). Gently replace the

water container back to its original position. Do not press

the water container, it may cause the failure of the appli-

ance.

When the water in the water container reaches a prede-

termined level, the display will show “P1: and the water

full indicator will start to ash (red). Gently remove the

water container and dispose of the water (see picture

below). Replace the water container back to its original

position. The red light will stop ashing and the “P1” sym-

bol will disappear. The appliance will continue to operate

properly.

Note: Remove the water container slowly to prevent water from splashing. The water full indicator will begin to ash and the display

will show the symbol “P1” when the water container is removed / displaced or when the predetermined water level is reached.

CLEANING AND MAINTENANCE

1. Unplug the appliance before cleaning.

2. Do not use abrasive detergents such as emulsions, cream cleaners, polishes, etc. to

clean the housing. They may remove the graphic information symbols.

3. Wipe the housing with a damp cloth. Do not wash the appliance directly under a tap or

using a water hose. Electric shock risk.

4. If the air lter is blocked with a large amount of dust, the air ow volume will be re-

duced. Clean the air lter every two weeks.

Opening and cleaning the air lter

1. Remove the lter cover and take out the air lter.

2. Wash the air lter by immersing it gently in warm water (about 40°C) with a neutral de-

tergent. Rinse the lter and dry in a shady place.

3. Attach the lter to the lter cover using the attachment hooks on the inner surface of the

cover.

4. Put the ler cover back to the appliance.

Power cord and plug

Pull the projection to open the power cord compartment.

Keep the power cord and plug clean. Roll up the power cord and store it in the power com-

partment if the appliance is not used for a long time.

BEFORE THE START OF THE SEASON

1. Check if the air inlets and outlets are not blocked.

2. Make sure the air lter is properly installed before operating the air conditioner. If the

air lter removed, dust and foreign objects may result in faulty performance of the appli-

ance.

BEFORE THE END OF THE SEASON

1. Switch off and unplug the air conditioner.

2. Clean the air lter and other parts.

3. Remove the water container. Beside the continuous drain hose you will nd a section of

hose that is plugged at the end. Remove the plug from the hose. Water from the bottom

tray will be removed through the drain hose.

4. Cover the appliance to protect it from dust and dirt.

Band

Remove

the drain plug

Hose

Band

Power cord

compartment

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zelmer 23Z010 Seite 54

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info