Bedienungsanleitung Zelmer Clarris Twix 2750.0 ST (Seite 42 von 46) (Englisch, Polnisch)

539664

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

48 2750-001_v04

Switch on the vacuum cleaner by pressing the “on/off”

button (7).

The vacuum cleaner is equipped with an electronic power

control which allows to gradually adjust the vacuum cleaner

suction power during operation. To adjust the suction power

use the power adjustment buttons (11,9) – to increase the

suction power or – to decrease the suction power. The

suction power setting is indicated by the appropriate number

of lit diodes.

The vacuum cleaner will by default begin operation at the high

power. 4 diodes will light on the power level indicator (10).

The suction power may be adjusted during operation. The

recommended settings are:

Setting 1 – vacuuming curtains

Setting 2 – vacuuming upholstery

Setting 3 – costeffective power

Setting 4 – vacuuming carpets

Setting 5 – vacuuming hard oors and crevices.

Set the desired power value by pressing the power

adjustment buttons , (11,9).

SAFBAG dust bag disassembly/assembly

The vacuum cleaner is equipped with a dust bag full

indicator (8). When the dust bag full indicator (8) lights

during operation (with the nozzle or the brush lifted above

the cleaned surface) it means that the bag is full and needs

to be replaced. In addition the dust bag full indicator (8) may

activate if the suction hose or the elements attached to the

suction hose are clogged (suction power – level 5).

Switch off the vacuum cleaner by pressing the “on/off”

button (7) and unplug the appliance.

Press the two side buttons on the end of the hose and

remove the hose end from the inlet opening of the vacuum

cleaner.

Release the upper cover fastening (12) and open the cover.

Remove the SAFBAG dust bag module (21) from the

vacuum cleaner chamber

Grab the dust bag cover, gently bend it towards the

inside and remove the whole dust bag upwards.

Insert the plate of the new dust bag in the tracks of the

SAFBAG dust bag module (21) and slide it until stop. The

direction for inserting the dust bag is indicated by the arrow

on the bag.

Slide the SAFBAG dust bag module together with the

installed bag in the tracks located on the side of the vacuum

cleaner chamber. Close the cover by pressing it until you

hear a characteristic click – pay attention not to trap the

dust bag.

DonotvacuumwithouttheSAFBAGdustbag

module/the“CYKLON”dustcontainerinstalled

intheappliance.ThelackoftheSAFBAGdust

bag module/the “CYKLON” dust container

preventsfrom locking the upper coverof the

appliance.

ZELMER vacuum cleaners are equipped with SAFBAG dust

bags in the amount indicated in the table. It is recommended

to replace the dust bag if:

a) a)the SAFBAG dust bag /”CYKLON” dust container full

indicator will lit up,

b) the vacuum cleaner operates poorly,

c) the dust bag is full.

Disassembly/assembly of the “CYKLON”

dust container

The vacuum cleaner is equipped with a removable dust

container “CYKLON” in which dirt is accumulated. The dust

container “CYKLON” must be emptied once full.

Switch off the vacuum cleaner by pressing the “on/off”

button (7) and unplug the appliance.

Press the two side buttons on the end of the hose and

remove the hose end from the inlet opening of the vacuum

cleaner.

Release the upper cover fastening (12) and open the

cover.

Remove the “CYKLON” dust container from the vacuum

cleaner chamber.

Pull aside the fastenings on the “CYKLON” dust container

and open the container. Empty the dirt from the container.

Afterperformingthisactivity,checkthebasic

HEPA12lterandifnecessarycleanorreplace

thelter.

Close the cover of the “CYKLON” dust container, rmly

press the fastenings until you hear a characteristic “click”.

The container must be tightly closed.

Otherwise the dust might enter the vacuum

cleanerchamberandthesuctionpowerwillbe

reduced.

Insert the empty “CYKLON” dust container into the

vacuum cleaner chamber.

Close the cover by pressing it until you hear

a characteristic click.

Filter disassembly

The vacuum cleaner is equipped with a lter element with

cyclone ltration which allows for vacuuming without the

traditional dust bag. A characteristic feature of the cyclone

lter is the use of the air stream whirl to separate solid dirt.

The separation of dirt takes place in the part of the container

with the circle cross section in which the whirling air pushes

the dirt on the wall of the container and next through an

opening to the adjacent chamber of the container. The

initially cleaned air is directed to the cone shaped HEPA 12

lter which retains even the nest dirt fractions. The HEPA 12

lter is equipped with a mesh protection which limits the

accumulation of dirt on the operating surface of the lter, due

to which the service life of the HEPA 12 lter is longer.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zelmer Clarris Twix 2750.0 ST Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info