539666

Zelmer Eco Power VC3100.0 SK Seite 63

63
Zoom out
Zoom in
Vorherige Seite
1/66
Nächste Seite
67
VC3100-001_v01
5
Carefully insert a new / rinsed lter to previously occupied
space.
6
Put the lter cover so that two tips located at the right
side of the cover should hit the holes in the body of the
vacuum cleaner, press the lter cover so the hook snapped
in the body. Characteristic “click” sound informs, that the lter
cover has been properly installed.
Donot use the vacuumcleaner withno inlet
andoutletltersmountedinthedevice.
Damagedinletandoutletltersmustbealways
replacedwithnew,factoryoriginallters.
THE CONE OF “CYCLONE” DUST CONTAINER
It is necessary to clean periodically the “CYCLONE” dust
container cone.
1
Disassembly “CYCLONE” dust container according to
point (C).
2
Press the button located on “CYCLONE” dust container
and open the bottom of the container. If “CYCLONE dust
container is full, empty it according to the point (C).
3
Turn the cone left, so the two tips located on the ange of
the cone were put out from the slots of the container. Put out
the cone.
4
If the “CYCLONE” dust container cone (17) is dirty, you
can rinse it with running water. Do not forget to dry above
mentioned cone before re-installation.
5
Insert the rinsed cone of “CYCLONE” dust container into
the container slot so the tip located on the ange of the cone
was in the slot of container’s body. Turn right the cone so that
the two tips located on the ange of the cone were blocked in
the slots of the container.
6
Snap the bottom of “CYCLONE” dust container. Please
pay attention to the proper positioning of seal found on the
bottom of the container.
7
Insert “CYCLONE” dust container to vacuum cleaner
chamber. The characteristic “click” indicates that the
container has been correctly mounted.
End of operation, cleaning and
maintenance
1
Switch off vacuum cleaner pressing On/Off switch (4).
2
Put the connection cable plug out the wall outlet.
3
Wind the cable by pressing retractor button (6).
Performing this action, hold the power cable to avoid any
tangles and shocking the vacuum cleaner body with the
plug.
4
Disconnect telescopic suction tube and a sucker or
a brush sweeper.
5
Disconnect telescopic suction tube and a hose.
6
Press the two side buttons located at the hose end, then
remove the hose end from vacuum cleaner inlet hole.
F
G
it or rinse with running water. Do not forget to dry above
mentioned lter before re-installation.
The main function of the foam inlet lter (15) is to protect
HEPA inlet lter (14) against excessive dirt.
Forsafetyreasonsitisunacceptabletoinstall
themoistordamagedfoaminletlter(15).
Clean the pleats of HEPA inlet lter
●
(14), in case of lter
damage it should be absolutely replaced with a new
lter. If HEPA inlet lter (14) is dirty, you can replaced
it with a new lter, you can clean it or rinse with running
water. Do not forget to dry above mentioned lter before
re-installation.
Forsafetyreasonsitisunacceptabletoinstall
themoistordamagedinletlterHEPA(14).
Insert a new/rinsed HEPA inlet foam lter
●
(15) into
previously occupied space.
3
Insert a new/rinsed HEPA inlet lter (14) to the dust
container into previously occupied space.
4
Insert “CYCLONE” dust container with mounted HEPA
inlet lter (14) to vacuum cleaner chamber. The characteristic
“click” indicates that container has been correctly mounted.
ItisrecommendedtoreplaceHEPAinletlter
(14)withanewoneevery6monthsofuse.
Do not vacuum withoutHEPA inlet lter (14)
installed in “CYCLONE” dust container. Lack
ofHEPAinletlter(14)shallpreventinsertion
of “CYCLONE” dustcontainer tothe vacuum
cleaner.
“MICROFILTER” OUTLET FILTER AND OUTLET
FOAM FILTER
1
In order to replace “Microlter” outlet lter (12) press the
hook located in the lter cover and pull out the lter cover
from vacuum cleaner.
2
Pull out the “Microlter” outlet lter (12).
If the “Microlter” outlet lter (12) is dirty, you can replace
it with a new lter, you can clean it or rinse with running
water. Do not forget to dry above mentioned lter before
re-installation.
Forsafetyreasonsitisunacceptabletoinstall
the moist or defective “Microlter” outlet
lter(12).
3
Carefully insert a new / rinsed lter to previously occupied
space.
4
Pull out the foam outlet lter from lter cover (1).
If the outlet foam lter (13) is dirty, you can replace it with
a new lter, you can clean it or rinse with running water. Do
not forget to dry above mentioned lter before re-installation.
Forsafetyreasonsitisunacceptabletoinstall
themoistordamagedoutletfoamlter(13).
E
… 63 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Zelmer Eco Power VC3100.0 SK wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info