Bedienungsanleitung Zelmer JE1000 (Seite 47 von 50) (Englisch, Polnisch)

540082

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

49JE1000-001_v01

Technical data

The technical data are given on the name plate.

Maximum continuous operation time: 10 minutes

Time interval between successive uses: 15 minutes

Noise level (L

) 80 dB/A

The juice extractor type JE1000 does not require connection

to a grounded socket .

ZELMER appliances satisfy the requirements of relevant

standards.

The appliance meets the requirements of the following

directives:

Low Voltage Device (LVD) – 2006/95/EC; –

Electro-Magnetic Compatibility (EMC) – 2004/108/EC. –

The product is marked with CE symbol on the name plate.

Construction of the appliance (Fig. A)

Motor unit

Suction cups

Power cord

Power on/off button, level 1 – level 2

Locking clamps

Fasteners

Skimmer

Juice bowl

Spout

Pulp container

Strainer

Lid

Pusher

Jug

Froth separator

Brush

Preparing for operation (disassembling) (Fig. B)

Before rst use, disassemble the appliance,

wash and dry all attachments in contact with

the processed fruit or vegetables.

Place the appliance on a clean hard, and dry surface

near a wall socket.

Hold the locking clamps (5) from below on both sides

and pull away from the motor unit.

Lift locking clamps (5) to release the lid (12) and lower

when released.

Remove the pulp container (10) and the pusher (13).

Remove the lid (12) and the juice bowl (8) together with the

strainer (11).

Wash all parts (except the motor unit) carefully

in hot water with wash-up liquid. You can

also clean them in a dishwasher at max. 60°C

(except the strainer and the motor unit). Once

clean, replace the parts after drying them rst

thoroughly.

Assembling the appliance (Fig. C)

Place the juice bowl (8) on the motor unit (1), inserting

the spout (9) in the opening of the motor unit casing.

Mount the strainer (11) on the skimmer (7), press it all the

way in, and check if it is well mounted and swivels easily.

Place the lid (12) on the juice bowl (8).

Lift up both clamps (5) and x them on to the fasteners

(6) located on the lid.

Press the clamps (5) to the motor unit (1) (you will hear

a characteristic click).

To mount the pulp container (10) under the lid (12),

proceed as follows: lean the pulp container (10) and place

it under the juice bowl (8). Then slide it in towards the motor

unit (1). Place the Jug (14) under the spout (9).

If you fail to assemble any of the parts (e.g. the

juice bowl, lid, pulp container or locking

clamps) or do it improperly, a safety device will

prevent the switch-on of the appliance.

Starting and operating the juice

extractor (Fig. D)

Make sure that the power on/off button is set to

●

“0”.

Unwind a sufcient length of the cord. The remaining

●

cord can be stored inside the drive housing. Slip the

remaining cord through an opening located at the side

of the appliance.

Insert the power cord (3) plug into the socket and

press the on/off button (4) to start the appliance, selecting

speed level 1 (position I – low rotation speed for soft fruit

and vegetables such as raspberries, tomatoes, cucumbers,

Tip

Product information and tips for use

Thoroughly clean all parts of your appliance before the

●

rst use.

The appliance is intended for domestic use. In case

●

it is used for food business purposes, the warranty

conditions shall change.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zelmer JE1000 Seite 47

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info