540047

Zelmer ZPG6155SZ Seite 25

25
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
25
PG-006_v01
Installation
GENERAL INSTRUCTIONS
THE MANUFACTURER IS NOT LIABLE FOR
ANY DAMAGE CAUSED BY A FAILURE TO
OBSERVE APPLICABLE STANDARDS AND
REGULATIONS, OR BY INSTALLING THE HOB
BY AN UNAUTHORISED PERSON.
The appliance may be installed only by
a certifi ed installation technician.
1
The appliance must be installed in a kitchen meeting the
requirements specifi ed by Building Law regulations (Journal
of Law No. 89 item 484). The kitchen:
should have appropriate volume, ensuring that the
●
maximum thermal load from the installed gas appliances
is not more than 930 W/m³,
should have a minimum height of 2.2 m,
●
should have supply and exhaust ventilation (allowing at
●
least 1.5 times exchange of air in an hour),
should have air infl ow (if there is no window) through
●
holes made in external walls, with a minimum area of
0.016 m²,
should have fumes exhaust, e.g. through an operating
●
chimney duct with a minimum size of 0.14 m.
2
The wall adjacent to the hob should be made of
infl ammable materials.
3
In order to limit the negative impact of drafts on the
burners, the hob should not be installed on the window-door
line.
4
Kitchen cabinets must not be mounted directly above the
hob. The distance between the side edges of the hob and
the side edges of the cabinets should be at least 50 mm.
5
To ensure appropriate absorption and exhaust of kitchen
fumes, it is recommended that a ventilation hood is installed.
The distance between the hob and the ventilation hood
mounted above it should be at least 700 mm.
Installation of the hob (Fig. A)
The appliance may be installed only by
a certifi ed installation technician.
The dimensions and assembling instructions are presented
in the fi gures above.
1
Before cutting an opening in the worktop, make sure
that the distance between the rear edge of the hob and the
wall is at least 55 mm. Cut out the opening in the worktop in
accordance with the dimensions.
2
Remove all unattached elements from the hob (pan
supports, burner caps, crowns, etc.).
3
Turn the hob upside down. Cut off 4 pieces of the
appropriate length from the seal, remove the protective tape
and stick them along the hob edges.
4
Place the hob in the opening and press fi rmly so that the
seal fi ts closely to the worktop. Fix the hob to the worktop
from the bottom with the use of fi xing clamps.
The appliance must be installed in accordance with
●
applicable building regulations regarding the installation
of gas devices in residential facilities.
Make sure the worktop is made of suitable heat resistant
●
material to avoid deformation due to heat produced by
the hob.
Connecting the gas hob
THE MANUFACTURER IS NOT LIABLE FOR
ANY DAMAGE CAUSED BY A FAILURE TO
OBSERVE APPLICABLE STANDARDS AND
REGULATIONS, OR BY INSTALLING THE HOB
BY AN UNAUTHORISED PERSON.
The hob must be connected to the power and
gas system only by a certifi ed installation
technician.
Before proceeding with connecting the hob to
the electrical and gas mains, make sure that
the gas valve is closed.
Before connecting the appliance to the
electrical and gas mains, read the information
on the rating label and in this manual.
CONNECTING THE HOB TO THE GAS MAINS
Before installation, make sure that the local distribution
●
conditions (gas type and pressure) and appliance
settings are appropriate.
The gas setting conditions for this appliance are given on
●
the rating label.
This appliance is not to be connected to exhaust pipes.
●
It should be installed and connected in accordance with
applicable installation regulations. Especially, appropriate
ventilation requirements should be met.
The fl exible gas pipe should be mounted in such a way
●
as to not touch any moving parts of furniture (e.g.
a drawer) and should not go through spaces with not
enough room.
After installing the hob, the technician is obliged to check
●
the tightness of the gas installation.
CONNECTING THE HOB TO THE ELECTRICAL
MAINS
The gas hob is equipped with a power cord
without a plug. The plug should be attached
to the power cord exclusively by a qualifi ed
electrician.
The socket to which the appliance is to be
connected should be easily accessible to the
user.
… 25 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Zelmer ZPG6155SZ wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info