EN
22
17
16
• Unscrew the electronic sensor by turning the knob anticlockwise, as
shown in Pict. 15.
• Use the specific funnel (6) to pour approximately half a glass of white
wine vinegar (approx. 0.1 litres) into the boiler. Fasten the sensor to the
boiler entrance by turning clockwise. Tighten without forcing.
• Return the appliance to its original position, and replace the tank. Close
the tank lid and refasten it, Pict. 1-6. Chapter 6.
• Connect the appliance to the mains and turn on as usual.
• Turn the boiler on by pressing the function button.
Wait approximately 1 minute, then turn the appliance off. Leave to work
for approximately 12 hours, remembering to shake the machine
a little every now and then, to let the descaling solution work better.
• Once the stated time has passed, unscrew the electronic sensor by
turning the knob anticlockwise (Pict. 15), take hold of the machine and
empty out the boiler using a basin or other such receptacle (Pict. 17).
For a more thorough cleaning of the electronic sensor, we advise you to use a
glass of white vinegar, or a mixture of water (70%) and descaler (30%).
Never use concentrated, undiluted descaling products!
You could chemically damage the sensor’s surface! Leave the product or
the vinegar to act on the sensor for at least 2 hours Pict. 16.
Fasten the sensor back onto the machine, by turning clockwise.
Tighten without forcing.
IMPORTANT! The first time the appliance is to be used following this
operation, remember to discharge a little steam onto a dirty cloth. Repeat this
several times, in order to empty the steam circuit of all descaling product.
The appliance is now ready for use once again!
Other machines, because of limescale deposits, can no longer detect water
levels; your TUTTOLUXO 6S however, thanks to a simple operation you can
carry out at home, can be as new. You will also be able to descale the boiler,
further prolonging the appliance efficiency.
We advise you to carry out this operation at least once a year, although the
amount of limescale forming in the boiler is very much dependent on the
hardness of your mains water. In any case, if you see a deterioration in your
machine steam functions performance, or limescale coming out of the steam
accessories, that means it’s time to descale sensor and boiler.
WARNING!
We advise you against using water with hardness exceeding 30°f (French
degrees).
Proceed as follows: finish off cleaning and wait for the machine to cool down
completely.
WARNING!
Never, for any reason, carry out your descaling operations when
the machine is still hot! Risk of burns! Wait at least two hours before
proceeding with any maintenance operation.
• Disconnect the plug from the mains.
• Remove the hose from the appliance, to make operations easier.
• Remove the tank lid and purification tank and empty completely.
• Carefully turn the machine upside down, identifying the sensor knob
(Pict. 14).
