Bedienungsanleitung Zibro Kamin HYBRID E (Seite 10 von 16) (Englisch)

460316

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

automatically after 65 hours continuous operation. The following will then appear

in the display: . If desired, you can switch the heater on again by pressing the

button

(see section D).

AUTOMATIC CLEANING MODE

When the heater has been burning continuously for two hours at its highest

setting, the burner will automatically start an autoclean procedure. The display

will show the autocleaningcode cl:05 running back to cl:01. The procedure takes 5

minutes, during which the heater will burn at its lowest setting, while the burner

autocleans. When the burner is clean again, the heater will automatically switch

back to the highest setting again.

J CHILDPROOF LOCK

The childproof lock can be used to prevent children accidentally changing the

heater settings. When the heater is burning and the childproof lock is on, the

heater can only be switched off. Other functions are blocked then. If the heater

has already been switched off, the childproof lock also prevents accidental ignition

of the heater. Activate the childproof lock by pressing the appropriate key N and

holding it down for more than 3 seconds. The KEY-LOCK indicator will appear

on the information display (Fig. H), indicating that the childproof lock has been

activated. Switch off the childproof lock by pressing the key N and holding it

down for more than 3 seconds once again.

K THE CORRECT USE OF ‘SAVE’

The ‘SAVE’ function allows you to limit the temperature. When this function is

activated, the heater will automatically switch off, when the room temperature

exceeds the set temperature by 3°C. Subsequently, when the room temperature

has dropped again to the set temperature, the heater will automatically switch on

again. Activate the ‘SAVE’ setting by pressing the appropriate Q key. The SAVE

indicator light will light up (Fig. I). Switch off the function by pressing the SAVE

key once again.

Without the ‘SAVE’ setting your heater will maintain the set temperature by

approximation as well, by adjusting its heating capacity. ‘SAVE’ is an economy

setting, which you can use when, for instance, you are not present in the room or

to keep it frost-free.

L THE ‘FUEL’ INDICATOR

When the FUEL indicator appears, it means that there is only fuel left for 10

more minutes. The count-down of the remaining heating time can be seen in the

information display (Fig. J). Now you have two options:

• you remove the fuel tank and refill it outside the living room (section B) or

• you push the button EXTENSION R. By pushing this button, the remaining

heating time will extend to 60 minutes. The heater will automatically switch

back to its lowest position. In the display the number 60 will appear, which

will decline to 10. At the arrival of 10, you will hear an alarm signal every two

H: When the mark

appears, the

childproof lock has been

activated.

J: When the FUEL

indicator has appeard,

the information display

will show the number of

minutes of fuel left in

the tank.

I: When the SAVE light

lights up, the heater will

automatically switch on

or off in order to remain

within a specified tempe-

rature range.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zibro Kamin HYBRID E Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zibro Kamin HYBRID E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info