Bedienungsanleitung Zibro Kamin SRE 150E (Seite 50 von 75) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch)

460431

Zoom out

Zoom in

Vorherige Seite

1/75

Nächste Seite

☞

ithout the 'SAVE' setting your heater will maintain the set temperature by

approximation as well, by adjusting its heating capacity. 'SAVE' is an economy

setting, which you can use when, for instance, you are not present in the room

or to keep it frost-free.

K THE 'FUEL' INDICATOR

When the FUEL indicator appears, there is enough fuel left for another 10 minutes

of heater use. The count-down of the remaining heating time can be seen in the

information display

Ƹ (Fig. J). Every two minutes an alarm signal is sounded,

warning you to refill the removable tank. If you do not react, the heater will

extinguish by itself. The heater will also sound a warning signal, when it switches

off. The FUEL indicator will blink, while four lines are blinking in the information

display. You can stop this by pressing the button

ƹ once.

Once the heater has used up all its fuel and is extinguished it will take some time,

after the refill, before the heater is completely ready for use again.

L THE 'VENT' INDICATOR

When there is insufficient ventilation in the room, an intermittent buzzer will be

heard (approximately once each ten minutes) and the VENT indicator will be lit. When

this signal is given, ensure that the ventilation of the room is improved (e.g. by

opening a door or window a little more), to avoid that the heater shuts off. When the

ventilation of the room is improved, the VENT indicator and buzzer will be

deactivated. When there is still insufficient ventilation, the heater shuts off

automatically. When this occurs,

e -1 1 is displayed and the VENT indicator is blinking.

After improving the ventilation of the room (e.g. by opening a door or window a little

more), the heater can be ignited by pushing the button

ƹ again.

M MAINTENANCE

Switch off the heater and let it cool down, before you start any maintenance

work. Also disconnect the plug from the mains. Your heater needs hardly any

maintenance. It is, however, important that you clean the air filter

¾ and the vent

filter

µ with a vacuum cleaner and the grid ᕢ with a damp cloth, both on a

weekly basis. Remove the air filter occasionally (Fig. L) and clean it with soapy

water. Prior to reinstallation, make sure that the air filter cap has fully been dried.

Regularly inspect the fuel filter as well:

Remove the removable tank

ᕧ from the heater and remove the fuel filter

(Fig. M). Some drops may leak from the filter; keep a cloth at hand.

Remove the dirt by tapping the fuel filter upside-down against a hard surface.

(Never clean it with water!)

Reinstall the fuel filter into the heater.

We recommend that you remove dust and stains from time to time with a damp

cloth, because other

wise these may cause stains that ar

e har

d to r

emove.

Fuel filter

K: A blinking VENT

indicator is a sign that

you need extra

ventilation.

: When the FUEL

indicator has appeard,

the information display

will show the number of

minutes of fuel left in

the tank.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zibro Kamin SRE 150E Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info