Bedienungsanleitung Zibro LC 135 (Seite 18 von 168) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

728823

Zoom out

Zoom in

Vorherige Seite

1/168

Nächste Seite

F: When the 4-digit

stops blinking, the set-

ting has been locked to

the indicated value.

B FILLING FUEL

ill the removable tank in a suitable place since there can alays be some

spillage. ollo the procedure belo:

Make sure that the heater is switched off.

Open the upper lid and lift the removable tank out of the heater (ig. B).

Put don the removable tank (cap pointing upards, handle on floor) and

scre off the fuel cap (ig. C).

NOTE: Some drops may leak from the tank.

ill the removable tank using a fuel pump (refer to fuel pump operation

instructions.) Make sure that it is in a higher position than the removable tank

(ig. ). Insert the ribbed hose into the opening of the removable tank.

Check the removable tank fuel gauge hile filling the tank (ig. E). Stop

filling once the gauge indicates that the tank is full. Never overfill the tank,

especially not when the fuel is very cold (fuel expands when it heats up).

Let the remaining fuel in the pump flow back into the jerrycan and carefully

remove the pump. Carefully screw the fuel cap back on the tank. Clean off

any spilled fuel.

Check whether the fuel cap is straight and tightened properly. Reinstall the

removable tank in the heater (cap down). Close the lid.

C SETTING THE CLOCK

It is only possible to set the correct time and day, when the heater is connected to

the mains and not burning. Use the adjustment keys  to set the time and exten-

sion/day/set (eekly timer)  to set the day.

irst press one of the three keys to sitch on the function (the -digit  will start

blinking). Next, set the hours using the key ( hour) and the minutes using the

key ( min.) and the day using the key etension/day/set .

Press once to increase the value by one step. When you hold don the key, the

value ill continue going up, until you release the key again. After approimately

10 seconds the -digit ill stop blinking and the setting ill be locked (ig.). 5

minutes after switching off the heater, the information on the display will disap-

pear and the heater ill automatically sitch into the stand-by position.

When the heater has been unplugged for more than 30 minutes (or after a

power failure), the time and the day need to be set again.

empty

full

D WEEKLY TIMER

Here is an example on how the weekly timer can be programmed:

• Maximum of 3 programs per day can be set.

• Every day of the week can be programmed separately.

• Minimum switching interval, 1 hour.

• Minimum activation time, 1 hour.

• Choice between manual and timer.

• Settings are saved in the memory and remain saved without power supply.

Monday Tuesday Wednesday Thursday Friday Saturday Sunday

P1 ON 6:30 6:30 6:30 6:30 6:30 10:00 9:00

P1 OFF 8:45 8:45 8:45 8:45 8:45 23:00 23:00

P2 ON 12:00 15:00 18:00 12:00 12:00

P2 OFF 14:00 23:00 23:00 14:00 14:00

P3 ON 18:00 18:00 18:00

P3 OFF 23:00 23:00 23:00

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zibro LC 135 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info