Bedienungsanleitung Zibro RC 270 (Seite 18 von 140) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Norwegisch)

728813

Zoom out

Zoom in

Vorherige Seite

1/140

Nächste Seite

F ADJUSTING THE WICK HEIGHT

After a period of time the combustion may no longer be high enough (Section D).

In that case you can adjust the wick height to improve the flame. To do this, the

heater must have been switched off. Follow the procedure below:

1 Push the OFF button  (Fig. N).

2 Pull the knurled wick adjustment knob  off the heater, so the wick height

lock  will be visible.

3 Take the plastic collar between your thumb and index finger and pull it out.

Turn the collar up one step, to either position 2 or 3 (Fig. O). Carefully push

the collar back, so the pin engages in the recess.

4 Carefully reinstall the knurled wick adjustment knob . This can be done in

one way only - check the rear of the cap for the correct position.

If adjustment of the wick height does not have the required effect, let the heater

burn until all fuel has been used up (Section H).

If the flame height is still too low and the wick is set on position 3, then contact

your dealer, or replace the wick, refer to Section M.

If the flame gets too high after adjusting (Fig R), the wick height lock should be

placed one position lower again. Otherwise smoke or soot may be caused.

G MALFUNCTION, CAUSES AND SOLUTIONS

If any malfunctioning cannot be solved from the directions below, please contact

your dealer.

THE HEATER DOES NOT IGNITE

 The batteries are not positioned correctly in the holder.

Check (Fig. F).

 There is not enough power left in the batteries for the ignition.

Replace (Fig. F).

 You have run out of fuel from the tank or the wick has been replaced.

After having refilled and replaced the removable tank, wait for 30 minutes

before igniting the heater.

IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS

 The combustion chamber  has not been positioned correctly.

Use the handle  to put it level, until you can easily slide it slightly to the left

and to the right and the chamber is level.

 You are using fuel which is past its ‘use by’ date.

Start every heating season with fresh fuel.

 You are using the incorrect type of fuel.

Refer to THE RIGHT FUEL (See Section ’What you need to know in advance’).

 Dust has gathered in the lower part of the heater.

Contact your dealer.

 Wick position wrong.

See Section F.

THE HEATER SLOWLY EXTINGUISHES

 The removable tank is empty.

See Section B.

 The fuel filter is contaminated by water.

Dry the fuel filter (Section H, Fig. P).

 The lower reservoir is contaminated by water.

Contact your dealer.

 The wick has hardened on the upper side.

Burn the heater until all fuel is used (Section H). Use the right fuel.

 You are using fuel which is past its ‘use by’ date.

Start every heating season with fresh fuel.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zibro RC 270 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info