Bedienungsanleitung Zibro s 1234 (Seite 14 von 22) (Englisch)

134334

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

H HOW THE AIR CONDITIONER WORKS

AUTOMATIC OPERATION

• When you set the air conditioner in AUTO mode (button 2 on the remote

controller), it will automatically select COOLING, HEATING or FAN only ope-

ration depending on what temperature you have selected and the room

temperature.

• The air conditioner will control room temperature automatically round the

temperature point set by you.

• If the AUTO mode is uncomfortable, you can select desired conditions manu-

ally.

ECONOMIC OPERATION

• When you push SLEEP button ቧ during COOLING, HEATING or AUTO opera-

tion, the air conditioner will automatically increase (cooling) or decrease

(heating) 1ºC per hour. The set temperature will be steady 2 hours later. The

fan speed will be automatically controlled.

DEHUMIDIFYING OPERATION

• The dehumidifying mode will automatically select the dehumidifying opera-

tion based on the difference between the set temperature and the actual

room temperature.

• The temperature is regulated while dehumidifying by repeatingly turning on

and off of the cooling operation or fan only. The fan speed is LOW.

•

In normal cooling operation the airconditioner will also dehumidify the air.



NOTE

When the airconditioner is dehumidifying it is likely that the room temperature will decrease. It is

therefore normal that a hygrostat will measure a higher

relative humidity. The absolute

humidity in the room will however be lowered, depending on the amount of moisture produced

in the room (cooking, people etc).



CAUTION

• The AIR DIRECTION and SWING buttons will be disabled when the air conditioner is not in

operation (including when the TIMER ON is set).

• Do not operate the air conditioner for long periods with the air flow direction set downward

in cooling or dry mode. Otherwise, condensation may occur on the surface of the horizontal

ouver causing moisture to drop.

• Do not move the horizontal louver manually. Always use the AIR DIRECTION

ቩ or SWING

button

ቨ. If you move this louver manually, it may malfunction during operation. If the louver

malfunctions, stop the air conditioner once and restart it.

• When the air conditioner is started immediately after it was stopped, the horizontal louver

ight not move for approximately 10 seconds.

• Open angle of the horizontal louver should not be set too small, as COOLING or HEATING

performance may be impaired due to too restricted air flow area.

• Do not operate unit with horizontal louver in closed position.

• When the air conditioner is connected to power (initial power), the horizontal louver may

generate a sound for 10 seconds, this is a normal operation.

114

Press Sleep button

COOLING

HEATING

DEHUMIDIFYING

Set

empe-

rature

1 hour

1 hour 1 hour

Set

Tempe-

rature

Set temperature

Time

Room

tempe-

rature

Cooling Fan only Cooling Fan only Cooling

man_S12xx_uk.qxd 26-01-2007 15:52 Pagina 114

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Zibro s 1234 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Zibro s 1234

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info