Bedienungsanleitung ZTE Unico LTE (Seite 29 von 34) (Englisch)

596077

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

54 55

Radio Frequency (RF) Energy

This model phone meets the government’s requirements

for exposure to radio waves.

This phone is designed and manufactured not to exceed

the emission limits for exposure to radio frequency (RF)

energy set by the Federal Communications Commission

of the United States, Industry Canada of Canada.

During SAR testing, this device is set to transmit at its

highest certiﬁed power level in all tested frequency

bands, and placed in positions that simulate RF

exposure in usage against the head with no separation,

and near the body with the separation of 0.4 inches

(10 mm). Although the SAR is determined at the

highest certiﬁed power level, the actual SAR level of the

device while operating can be well below the maximum

value. This is because the phone is designed to operate

at multiple power levels so as to use only the power

required to reach the network. In general, the closer you

are to a wireless base station antenna, the lower the

power output.

The exposure standard for wireless devices employs a

unit of measurement known as the Speciﬁc Absorption

Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg,

and 1.6 W/kg by Industry Canada.

This device is compliance with SAR for general

population/uncontrolled exposure limits in ANSI/IEEE

C95.1-1992 and Canada RSS 102, and had been tested

in accordance with the measurement methods and

procedures speciﬁed in OET Bulletin 65 Supplement C,

and Canada RSS 102. This device has been tested, and

meets the FCC, IC RF exposure guidelines when tested

with the device directly contacted to the body.

The FCC has granted an Equipment Authorization for

this model phone with all reported SAR levels evaluated

as in compliance with the FCC RF exposure guidelines.

SAR information on this model phone is on ﬁle with the

FCC and can be found under the Display Grant section

of www.fcc.gov/oet/ea/fccid after searching on FCC

ID: SRQ-Z930L.

For this device, the highest reported SAR value for

usage against the head is 0.78 W/kg, for usage near

the body is 1.17 W/kg.

While there may be differences between the SAR levels

of individual Z930L phones and at various positions,

they all meet the government requirement.

SAR compliance for body-worn operation is based on

a separation distance of 0.4 inches (10 mm) between

the unit and the human body. Carry this device at least

0.4 inches (10 mm) away from your body to ensure RF

exposure level compliant or lower to the reported level.

To support body-worn operation, choose the belt clips

or holsters, which do not contain metallic components,

to maintain a separation of 0.4 inches (10 mm)

between this device and your body.

RF exposure compliance with any body-worn accessory,

which contains metal, was not tested and certiﬁed, and

using such body-worn accessory should be avoided.

FCC Compliance

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired

operation.

CAUTION: Changes or modiﬁcations not expressly

approved by the manufacturer could void the user’s

authority to operate the equipment.

NOTE: This equipment has been tested and found

to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorientorrelocatethereceivingantenna.

• Increasetheseparationbetweentheequipmentand

receiver.

• Connecttheequipmentintoanoutletona

circuit different from that to which the receiver is

connected.

• Consultthedealeroranexperiencedradio/TV

technician for help.

Using Your Phone With a

Hearing Aid Device

Your Z930L is compliant with the FCC Hearing Aid

Compatibility (HAC) requirements. For additional HAC

information, including the HAC rating of this product,

please refer to www.zteusa.com/support_page/.

When some wireless phones are used near some

hearing devices (hearing aids and cochlear implants),

users may detect a buzzing, humming, or whining

noise. Some hearing devices are more immune than

others to this interference noise, and phones also

vary in the amount of interference they generate. The

wireless telephone industry has developed ratings for

some of their mobile phones to assist hearing device

users in ﬁnding phones that may be compatible with

their hearing devices. Not all phones have been rated.

Phones that have been rated have a label on the box.

Your Z930L has been tested for hearing aid

device compatibility and has an M3/T4 rating.

These ratings are not guaranteed. Results will vary,

depending on the level of immunity of your hearing

device and the degree of your hearing loss. If your

hearing device happens to be vulnerable to interference,

you may not be able to use a rated phone successfully.

For Your SafetyFor Your Safety

ZTE Unico LTE Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info