Bedienungsanleitung ZyXEL NWD6505 (Seite 34 von 40) (Englisch)

544183

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Appendix A Legal Information

NWD Series User’s Guide

Certifications

注意 !

依據低功率電波輻射性電機管理辦法

第十二條經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用

者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。

第十四條低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現

有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。

前項合法通信，指依電信規定作業之無線電信。低功率射頻電機須忍

受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

本機限在不干擾合法電臺與不受被干擾保障條件下於室內使用。

減少電磁波影響，請妥適使用。

Notices

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the

equipment.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Viewing Certifications

Go to http://www.ZyXEL.com to view this product’s documentation and certifications.

Federal Communications Commission (FCC) Interference Statement

The device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:

 This device may not cause harmful interference.

 This device must accept any interference received, including interference that may cause undesired operations.

This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable prot

ection against harmful interference in a residential installation. This device generates, uses,

and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this device does cause harmful interference to radio/television reception, which

can be determined by turning the device off and on, the

user is encouraged to try to correct the interference by one or more of the following measures:

1 Reorient or relocate the receiving antenna.

2 Increase the separation between the equipment and the receiver.

3 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4 Consult the dealer or an experienced radio/TV technician for help.

FCC Cau

tion: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority

to operate this equipment.

FCC Radiation Exposure Statement

 This device has been tested to the FCC exposure requirements (Specific Absorption Rate).

 This device complies with the requirements of Health Canada Safety Code 6 for Canada.

 Testing was performed on laptop computers with antennas at 5mm spacing. The maximum SAR value is: 0.77

W/kg. The device must

not be collocated with any other antennas or transmitters.

 This equipment has been SAR-evaluated for use in laptops (notebooks) with side slot configuration.

 The device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment, under 47 CFR 2.1093 paragraph

(d)(2). End users must follow the specific operating instructions for satisfying RF exposure compliance.

To maintain compliance with

FCC

RF exposure compliance requirements, please follow operation instruction as documented in this manual.

 This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

ms.

ore than

specific

 IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels 1 through 11.

 This device is operated in the 5.15~5.25GHz frequency range, it is restricted to use in indoor environments only.

Important Note

This EUT is compliant with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and has been tested in

accordance with the measurement methods and procedures specified in OET Bulletin 65 Supplement C.

Industry Canada Statement

This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:

1) this device may not cause interference and

2) this device must accept any interference, including interference that may cause undesired operation of the device

This device ha

s been designed to operate with antennas having a maximum gain of 2.9 dBi.

Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 oh

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the EIRP is not m

required for successful communication.

IC Radiation Exposure Statement

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the

operating instructions for satisfying RF exposure compliance.

Note: for product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.

ZyXEL NWD6505 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ZyXEL NWD6505

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info