688688
305
Zoom out
Zoom in
Vorherige Seite
1/421
Nächste Seite
Chapter 23 Voice
VMG/XMG Series User’s Guide
305
SIP Service Domain
The SIP service domain of the VoIP service provider is the domain name in a SIP URI. For example, if the
SIP address is 1122334455@VoIP-provider.com
, then “VoIP-provider.com” is the SIP service domain.
SIP Registration
Each Zyxel Device is an individual SIP User Agent (UA). To provide voice service, it has a public IP address
for SIP and RTP protocols to communicate with other servers.
A SIP user agent has to register with the SIP registrar and must provide information about the users it
represents, as well as its current IP address (for the routing of incoming SIP requests). After successful
registration, the SIP server knows that the users (identified by their dedicated SIP URIs) are represented by
the UA, and knows the IP address to which the SIP requests and responses should be sent.
Registration is initiated by the User Agent Client (UAC) running in the VoIP gateway (the Zyxel Device).
The gateway must be configured with information letting it know where to send the REGISTER message,
as well as the relevant user and authorization data.
A SIP registration has a limited lifespan. The User Agent Client must renew its registration within this
lifespan. If it does not do so, the registration data will be deleted from the SIP registrar's database and
the connection broken.
The Zyxel Device attempts to register all enabled subscriber ports when it is switched on. When you
enable a subscriber port that was previously disabled, the Zyxel Device attempts to register the port
immediately.
Authorization Requirements
SIP registrations (and subsequent SIP requests) require a username and password for authorization. These
credentials are validated via a challenge / response system using the HTTP digest mechanism (as
detailed in RFC 3261, "SIP: Session Initiation Protocol").
SIP Servers
SIP is a client-server protocol. A SIP client is an application program or device that sends SIP requests. A
SIP server responds to the SIP requests.
When you use SIP to make a VoIP call, it originates at a client and terminates at a server. A SIP client
could be a computer or a SIP phone. One device can act as both a SIP client and a SIP server.
SIP User Agent
A SIP user agent can make and receive VoIP telephone calls. This means that SIP can be used for peer-
to-peer communications even though it is a client-server protocol. In the following figure, either A or B
can act as a SIP user agent client to initiate a call. A and B can also both act as a SIP SIP user agent to
receive the call.
305

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

zyxel-vmg8623-t50a

Suche zurücksetzen

  • The Zyxel Device will not be able to join the workgroup if your local area network has restrictions
    set up that do not allow devices to join a workgroup. In this case, contact your network
    administrator. Eingereicht am 10-8-2021 16:14

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für ZyXEL VMG8623-T50A wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info