Bedienungsanleitung AAS Strum Acoustic GS-1 (Seite 62 von 91) (Englisch)

541314

Zoom out

Zoom in

Vorherige Seite

1/91

Nächste Seite

62 Parameters

Additional information on the chord is available at the top of the display above the name of the

chord itself. When the chord detected contains no third or no ﬁfth the corresponding no 3 or no 5

message is highlighted. Finally, while Strum can recognize a great variety of chords and ﬁnd most

voicings used by guitar players, it is possible that it will not ﬁnd a voicing in its chord database for

a particular chord played on the keyboard. In these cases, the no match message is lit. Strum will

still display the chord name and propose a guitar voicing constructed according to a certain set of

rules. The chord should still sound right but the message is displayed in order to indicate that the

voicing chosen by Strum is probably very difﬁcult to play on the guitar and might therefore not be

commonly used by guitar players.

6.7.2 Chord

On the guitar, chords can be voiced in many different

ways. The speciﬁc voicing chosen by Strum for a chord de-

pends on the Type parameter. One can choose between open,

movable and drop chords as described in section 4.6. The

voicing can also be made more precise by specifying what

should be the lowest note of the chord played by Strum. In

root position, the lowest note of the guitar voicing is always the root of the chord played on the

keyboard and detected by Strum. In lowest position, the lowest note of the voicing follows the

lowest note played on the keyboard. It is also possible to tell Strum in which neck position to play

chords using the Playing Position parameter. The position is speciﬁed in fret number and indicates

the lowest fret on which the lowest note of the chord should be played. It is not always possible to

satisfy this constraint and Strum will respect this position whenever it is possible. This parameter

is of course only valid for movable chords and it is therefore inactive when open chords are chosen.

The last parameter in the Chords section is called Time. This parameter is used to control the

delay between the moment a chord is played on the keyboard and the moment it is triggered by

Strum. This parameter is necessary because when a chord is played on the keyboard, the notes are

not necessarily played simultaneously. Strum must therefore wait a certain time before sending a

group of notes to the chord detection module in order to make sure that it has received all the notes

which are supposed to form the chord. This delay should not be smaller than the interval between

the moment the ﬁrst and last notes are played. Using a value too small for this parameter will result

in individual notes of the chord being played before is is actually strummed. The value of this

parameter should vary depending on the playing skill and style of the keyboard player and should

be adjusted to a value allowing enough time for a chord to be played on the keyboard and be well

detected by Strum.

6.7.3 Loop

The loop player is used to control Strum with MIDI loops. Loops can contain both chords and

strumming key sequences. In this case, playing a loop is similar to playing a tune. Loops can also

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AAS Strum Acoustic GS-1 Seite 62

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info