677193
29
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
29
2.6 Recording IR Channels from another Transmitter
Make sure the batteries in both transmitters are fully charged. Do not use the transmitters in
intense light (e.g., sunlight) when programming.
Place the two transmitters on a table with the original transmitter directed towards the rear
of your Control Medi, see picture.
1. First
---
and then simultaneously press
1
for 2 seconds. When
you release the buttons the “Setting” alert sounds and the
indication lamp on button 1 flashes.
2. Press
1
.
3. Choose the level where the channels are to be recorded with
---
.
4. Press the button
X
where the channel is to be recorded. The
indicator light for the selected button glows steadily and the
“Press” alert sounds.
5. Press and hold the corresponding button
Y
on the original
transmitter pressed. Release the button when the indicator light
for the selected button goes off and the “Release” alert sounds.
This may take up to 10 seconds. If the indicator light glows again
and the “Press” alert sounds, you should press the button one or
more times until the “Success” alert sounds.
If the “Error” alert sounds, the recording has failed. Try again
from step 4.
6. If the recording of the first button was successful, repeat steps 4
and 5 until all buttons are programmed.
7. Finish by pressing
---
for 2 seconds.
8. If the action is successful, the “Success” alert sounds. If
something goes wrong or takes too long, the “Error” alert sounds.
9. Now test your recorded functions on the device that is to be
controlled.
Recording IR Channels
Press
---
+
1
2 sec
,
1
, choose the level with
---
, select button
X
, select button
Y
,
then continue or finish with
---
2 sec
Important! When just one level is used, the Level button automatically becomes the next
levels first button, see Table 1. It means that it is possible to record an IR channel on the
Level button, but only when just one level is being used.
Original
transmitter
29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Abilia 429220 Gewa Control Medi Standard wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Abilia 429220 Gewa Control Medi Standard

Abilia 429220 Gewa Control Medi Standard Bedienungsanleitung - Deutsch, Französisch - 44 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info