Bedienungsanleitung Abus FU9000 (Seite 16 von 96) (Englisch)

554031

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

6-16

6.2.3 Fixing the faceplate

Before fixing the faceplate, first read the following sections (up to page 5-20) and then return here. The preceding sections are

not needed for every installation.

When carrying out the following, make sure that the voltage is disconnected for all connection work. Both the power adapter

and the standby batteries must be disconnected.

Before fixing the faceplate, the following installation work should be complete.

• Telephone and power are connected to the PCB of the base plate (section 5.3).

• All connection work for additional control cables is completed on the PCB of the base plate (section 5.5).

• The brightness is adjusted (section 5.4).

• All jumpers are plugged in according to the desired function (section 5.7).

When all these jobs are completed, replace the faceplate and screw it tight. Proceed as follows:

• Connect the flat cable of the faceplate to the base plate.

• Insert the temper spring into the casing for the tamper opening and clip the faceplate from above into the

base plate.

• Fold the faceplate down until it clicks audibly into the base plate.

• Screw the case together from below using the screw provided.

The ABUS wireless alarm system is now ready for the following installation steps described in chapter 6.

6.3 How do I install the power and telephone connections?

The ABUS wireless alarm system is powered by a 230V AC power adapter with 9V AC. In this step, make sure only the

secondary power adapter plug is plugged into the base plate (see number 5 on page 5-14: What is what inside the

ABUS wireless

alarm system

?). The power adapter plug must never be plugged into the mains socket. The socket for the power adapter is on the

PCB in the base plate.

Alternatively, the power adapter plug can be connected directly to the base plate after the plug has been removed. The polarity is

unimportant.

For the telephone connection, you can use either an RJ45 plug or an RJ11 plug. The two analogue telephone cables a and b can

also be connected to the screw clamp as shown in the graphic. Here too, the polarity is unimportant. One or more telephone

terminal devices can be connected, but they must be connected after the

ABUS wireless alarm system. The reason: In the event

of an alarm, the system separates the connection to any series-connected telephone terminal devices and then uses this telephone

connection exclusively for transmitting the alarm message (blockade switching). In this way, you prevent a “busy” telephone from

blocking the line in the event of an alarm. To connect your telephone terminal devices to the system, see the above sketch. The

cables of your telephone line must be connected to the

Line connector of the ABUS wireless alarm system. Connect the cables of

your telephone or PBX to the

Set connector.

6.4 How do I adjust the contrast of the LCD display?

The ABUS wireless alarm system has a dimmer for adjusting the brightness and contrast of the LCD display. You should make

adjustments after plugging into the power supply and before replacing the faceplate on the base plate.

To make this setting, turn the LCD light dimmer (see number 8 on page 5-14: What is what inside the ABUS wireless alarm system?)

carefully with a small flat screwdriver until you have set the right brightness.

9 V AC connector

RJ31

Line/Set

RJ11

Line/Set

Screw

terminal

a/b Set

Screw

terminal

a/b

Line

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Abus FU9000 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Abus FU9000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info