Bedienungsanleitung ACP RCS10TS (Seite 11 von 17) (Englisch)

660229

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

User Options (Electronic Control)

Changing user options

Options such as single or double key programming, beep volume, and

maximum cooking time can be changed to suit individual preferences.

To change options:

1. Open oven door.

• If door is closed or STOP/RESET key is pressed before programming is

complete, changes are discarded and microwave exits programming

mode.

2. Press and hold key 2 for approximately 5 seconds.

• This begins options mode.

• Microwave will beep and 0P: -- displays. Microwave is now in

programming mode.

3. Press number key that controls option to be changed.

• See table below for options.

• Current option will display.

4. Press number key again to change the option.

• Each time key is pressed, option will change.

• Match number code displayed with descriptions for desired option.

5. Press START key to save changes.

• 0P: -- shows in display.

• To change additional options, repeat steps 3 and 4.

• Changes appear after door is closed or STOP/RESET pad is pressed.



Factory settings are marked in bold.

To change the oven back to the

factory setting, simply select the

option that is marked in bold.





In order for any changes to

be saved, the START key

must be pressed after selecting an

option. Shutting the oven door or

pressing the STOP/RESET key will

not save changes.

Numbered Keys Display Options (Factory Settings in Bold)

End of Cycle Beep

OP:10

OP:11

OP:12

3 second continuous beep.

Continuous beep until door is opened.

5 beeps bursts until door is opened.

Key Beep Volume

OP:20

OP:21

OP:22

OP:23

Eliminates beep.

Sets volume to low.

Sets volume to medium.

Sets volume to high.

Key Beep

OP:30

OP:31

Prevents beep when key is pressed.

Allows beep when key is pressed.

Active Display

OP:40

OP:41

OP:42

OP:43

15 seconds after oven door is opened, keyboard disabled.

30 seconds after oven door is opened, keyboard disabled.

1 minute after oven door is opened, keyboard disabled.

2 minutes after oven door is opened, keyboard disabled.

On-the-Fly Cooking

OP:50

OP:51

Prevents different pre-programmed keys to be activated during cooking.

Reset to Ready Mode

OP:60

OP:61

Opening oven door does not reset oven back to ready mode.

Maximum Heating Time

OP:70

OP:71

Allows 60 minutes of heating time.

Allows 10 minutes of heating time.

Manual Operation

OP:80

OP:81

Allows use of preprogrammed keys only.

Allows use of manual time entry and preprogrammed keys.

Double Digit Operation

OP:90

OP:91

Allows 10 (0-9) preprogrammed keys.

Allows 100 (00-99) preprogrammed keys.

Allows different pre-programmed keys to be activated during cooking.

Opening oven door resets oven back to ready mode.

Clean Filter Message

OP:00

OP:01

OP:02

OP:03

Oven will not display Clean Filter

Oven will display Clean Filter every seven (7) days

Oven will display Clean Filter every thirty (30) days

Oven will display Clean Filter every ninety (90) days

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ACP RCS10TS Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ACP RCS10TS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info