Bedienungsanleitung Acronis Disk Director 11 Advanced Server (Seite 59 von 94) (Englisch)

624424

Zoom out

Zoom in

Vorherige Seite

1/94

Nächste Seite

To convert a dynamic disk to basic

1. Right-click the dynamic disk you need to convert, and then click Convert to basic. You will receive

a final warning about the dynamic disk being converted to basic.

You will be advised about the changes that will happen to the system if the chosen disk is

converted from dynamic to basic. For example, if the disk you want to convert to basic contains

any volumes that are only supported by dynamic disks (all volume types except Simple volumes),

then you will be warned here about the possible damage to the data involved in the conversion.

2. Click OK to add the pending dynamic to basic disk conversion operation.

The results of the pending operation are immediately displayed as if the operation had been

performed.

To perform the pending operation you will have to commit it (p. 24). Exiting the program without

committing the pending operations will effectively cancel them.

After the conversion the last 8 MB of disk space is reserved for the future conversion of the disk from

basic to dynamic.

In some cases the possible unallocated space and the proposed maximum volume size might differ

(for example, when the size of one mirror establishes the size of the other mirror, or the last 8 MB of

disk space is reserved for the future conversion of the disk from basic to dynamic).

Boot disk conversion

The program does not require an operating system reboot after dynamic to basic conversion of the

disk, if:

1. There is a single Windows Server 2008, Windows Vista, or Windows 7 operating system installed

on the disk.

2. The machine runs this operating system.

Caution: The conversion of a disk containing boot volumes takes a certain amount of time. Any power loss,

unintentional turning off of the machine or accidental pressing of the Reset button during the procedure could

result in bootability loss.

The program ensures:

 the bootability of each of the operating systems, for machines where more than one operating

system is installed

 safe conversion of a dynamic disk to basic when it contains volumes with data for simple

volumes.

7.7 Changing a disk status: online to offline

This operation is available for Windows Vista SP1, Windows Server 2008 R2, Windows 7 operating

systems and applies to the current disk layout (p. 25).

The online status means that a basic or dynamic disk is accessible in the read-write mode. This is the

normal disk status. You may need to change an online disk to offline in order to protect it from

unintentional use, for example a disk is corrupted or has bad sectors.

To make a disk offline

1. Right click the online disk, and then click Change status to offline.

2. In the appearing window, click OK to confirm the operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Acronis Disk Director 11 Advanced Server Seite 59

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Acronis Disk Director 11 Advanced Server

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info