Bedienungsanleitung Aeg-electrolux df 6260 ml 1 (Seite 11 von 52) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch, Finnisch)

133536

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

EN - Instruction on mounting and use

Closely follow the instructions set out in this manual. All responsibility,

for any eventual inconveniences, damages or fires caused by not complying

with the instructions in this manual, is declined. The extractor hood has been

designed exclusively for domestic use.

Caution

WARNING! Do not connect the appliance to the mains until the installation is

fully complete. Before any cleaning or maintenance operation, disconnect

hood from the mains by removing the plug or disconnecting the mains

electrical supply. Always wear work gloves for all installation and

maintenance operations. The appliance is not intended for use by children or

persons with impaired physical, sensorial or mental faculties, or if lacking in

experience or knowledge, unless they are under supervision or have been

trained in the use of the appliance by a person responsible for their safety.

This appliance is designed to be operated by adults, children should be

monitored to ensure that they do not play with the appliance.

This appliance is designed to be operated by adults. Children should not be

allowed to tamper with the controls or play with the appliance.

Never use the hood without effectively mounted grating! The hood must

NEVER be used as a support surface unless specifically indicated. The

premises where the appliance is installed must be sufficiently ventilated,

when the kitchen hood is used together with other gas combustion devices

or other fuels. The ducting system for this appliance must not be connected

to any existing ventilation system which is being used for any other purpose

such as discharging exhaust fumes from appliances burning gas or other

fuels. The flaming of foods beneath the hood itself is severely prohibited.

The use of exposed flames is detrimental to the filters and may cause a fire

risk, and must therefore be avoided in all circumstances.

Any frying must be done with care in order to make sure that the oil does not

overheat and ignite. Accessible parts of the hood may became hot when

used with cooking applicance.

With regards to the technical and safety measures to be adopted for fume

discharging it is important to closely follow the regulations provided by the

local authorities.

The hood must be regularly cleaned on both the inside and outside (AT

LEAST ONCE A MONTH).

This must be completed in accordance with the maintenance instructions

provided in this manual). Failure to follow the instructions provided in this

user guide regarding the cleaning of the hood and filters will lead to the risk

of fires.

Do not use or leave the hood without the lamp correctly mounted due to the

possible risk of electric shocks.

We will not accept any responsibility for any faults, damage or fires caused

to the appliance as a result of the non-observance of the instructions

included in this manual.

This appliance is marked according to the European directive 2002/96/EC on

Waste Electrical and Electronic Equipment (WEEE). By ensuring this product

is disposed of correctly, you will help prevent potential negative

consequences for the environment and human health, which could otherwise

be caused by inappropriate waste handling of this product.

The symbol

on the product, or on the documents accompanying the

product, indicates that this appliance may not be treated as household

waste. Instead it should be taken to the appropriate collection point for the

recycling of electrical and electronic equipment. Disposal must be carried out

in accordance with local environmental regulations for waste disposal.

For further detailed information regarding the process, collection and

recycling of this product, please contact the appropriate department of your

local authorities or the local department for household waste or the shop

where you purchased this product.

Use

The hood is designed to be used either for exhausting

or filter version

Installation

The minimum distance between the supporting surface for the cooking

equipment on the hob and the lowest part of the range hood must be not

less than 43cm from electric cookers and 65cm from gas or mixed cookers.

If the instructions for installation for the gas hob specify a greater distance,

this must be adhered to. The mains power supply must correspond to the

rating indicated on the plate situated inside the hood. If provided with a plug

connect the hood to a socket in compliance with current regulations and

positioned in an accessible area, after installation. If it not fitted with a plug

(direct mains connection) or if the plug is not located in an accessible area,

after installation, apply a double pole switch in accordance with standards

which assures the complete disconnection of the mains under conditions

relating to over-current category III, in accordance with installation

instructions. Warning! Before re-connecting the hood circuit to the mains

supply and checking the efficient function, always check that the mains cable

is correctly assembled.

Operation

The hood is fitted with a control panel with aspiration speed selection control

and a light switch to control cooking area lights.

Use the high suction speed in cases of concentrated kitchen vapours. It is

recommended that the cooker hood suction is switched on for 5 minutes

prior to cooking and to leave in operation during cooking and for another 15

minutes approximately after terminating cooking. Use the keys or buttons

envisaged for the control of the lights and the power of the available suction.

Only in some models: switching on and off the fan that adjusts the suction

power and, in some cases, switching the lights on and off, is controlled by

opening and closing the steam collector.

Maintenance

ATTENTION! Before performing any maintenance operation, isolate the

hood from the electrical supply by switching off at the connector and

removing the connector fuse. Or if the appliance has been connected

through a plug and socket, then the plug must be removed from the socket.

The cooker hood should be cleaned regularly (at least with the same

frequency with which you carry out maintenance of the fat filters) internally

and externally. Clean using the cloth dampened with neutral liquid

detergent. Do not use abrasive products. DO NOT USE ALCOHOL!

WARNING: Failure to carry out the basic cleaning recommendations of the

cooker hood and replacement of the filters may cause fire risks.

Therefore, we recommend oserving these instructions.

The manufacturer declines all responsibility for any damage to the motor or

any fire damage linked to inappropriate maintenance or failure to observe

the above safety recommendations.

Grease filter - Fig. 3-12

The grease filter must be cleaned once a month using non aggressive

detergents, either by hand or in the dishwasher, which must be set to a low

temperature and a short cycle. When washed in a dishwasher, the grease

filter may discolour slightly, but this does not affect its filtering capacity.

Charcoal filter (filter version only) - Fig. 11

Type 150 - Washable activated charcoal filter

The charcoal filter can be washed once every two months using hot water

and a suitable detergent, or in a dishwasher at 65°C (if the dishwasher is

used, select the full cycle function and leave dishes out).

Eliminate excess water without damaging the filter, then remove the

mattress located inside the plastic frame and put it in the oven for 10 minutes

at 100° C to dry completely. Replace the mattress every 3 years and when

the cloth is damaged.

Type 60/80 - NON-washable activated charcoal filter

The saturation of the charcoal filter occurs after more or less prolonged use,

depending on the type of cooking and the regularity of cleaning of the grease

filter. In any case it is necessary to replace the cartridge at least every four

mounths. The charcoal filter may NOT be washed or regenerated.

Replacing lamps - Fig. 13

Disconnect the hood from the electricity.

Warning! Prior to touching the light bulbs ensure they are cooled down.

Extract the damaged light bulb and replace it with a new 9W-G23.

Aeg-electrolux df 6260 ml 1 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Aeg-electrolux df 6260 ml 1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info