98097
11
Zoom out
Zoom in
Vorherige Seite
1/18
Nächste Seite
The rotation of the kneading
pegs is blocked.
Check that the kneading pegs
are blocked by grains, etc. Pull
out the baking tin and check
whether the drivers turn. If this is
not the case, send the appliance
to the customer service.
The baking tin jumps up during
the kneading.
The side springs in the base
inside the inner casing have lost
tension.
Press the START/STOP key and
interrupt the program. Pull out
the container and push the
springs slightly to the side. Insert
the container again and close the
lid. Start the program over again.
The dough is too thick. The
kneading pegs are blocked and
the container is pressed
upwards.
Open the lid. Add some liquid to
the dough and close the lid
again.
The appliance does not start.
The display shows H:HH.
The appliance is still hot after the
last baking cycle.
Press the START/STOP key until
the basic setting appears on the
display. Remove the baking tin
and leave the appliance to cool.
Then put the baking tin back in,
set the program again and start.
Questions & Answers on the Recipes
Problem Cause Solution
The bread rises too fast. - Too much yeast, too much flour, not enough salt
- Or several of these causes
- a/b
The bread does not rise at all or
not enough.
- No yeast at all or too little
- Old or stale yeast
- Liquid too hot
- The yeast has come into with the liquid
- Wrong flour type or stale flour
- Too much or not enough liquid
- Not enough sugar
- a/b
- e
- c
- d
- e
- a/b/g
- a/b
The dough rises too much and
spills over the baking tin.
- If the water is too soft the yeast ferments more
- Too much milk affects the fermentation of the yeast
- f
- c
The bread goes down in the
middle.
- The dough volume is larger than the tin and the
bread goes down.
- The fermentation is too short or too fast owing to
the excessive temperature of the water or the
baking chamber or to the excessive moistness.
- a/f
-
c/h/i
The bread has a dip once the
baking is over.
- Not enough gluten in the flour
- Too much liquid
- k
- a/b/h
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

afk-bm-3

Suche zurücksetzen

  • Hallo, ich würde gerne die Bedienungsanleitung auf deutsch oder auf rumänisch!
    Ist das möglich? Eingereicht am 5-2-2022 19:13

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Afk BM-3 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Afk BM-3

Afk BM-3 Bedienungsanleitung - Holländisch - 21 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info